516902
16
Zoom out
Zoom in
Previous page
1/32
Next page
INSTALLATION
Place the rear of the unit at least 30 cm from the wall and ensure that there is at least 1.50 metres free
space at the front.
Screw the connector firmly to the hose and then connect it to the unit and the other end to the flat nozzle.
Connect the exhaust hose to the flat nozzle and place it as flexibly as possible in the window.
Ensure that no objects or plants are placed in front of the flat nozzle.
When you are certain that the above-mentioned rules have been followed and that no further dangerous
situations could arise, push the plug into the socket!
The unit is now ready for use
NORMAL USE
Press the POWER button to switch on the unit
Use the MODE button to select cooling, dehumidify or ventilator
Use the FANSPEED button to set the speed to High, Medium or Low
Please note: If the room is very hot and you have selected the COOLING function, you must select the lowest
speed. The air that is drawn into the unit will then have more time to cool, and the air in the room will be
cooled more quickly.
Use the ADJUST/ARROWS keys to select the correct temperature for the area in which the air conditioner is
located. After 15 seconds the actual ambient temperature, which is to be cooled, is re-displayed.
Please note: there is no guarantee that this temperature will actually be reached.
Please note: This unit has a built-in self-protection system. If the equipment is switched off, you should wait
for three minutes before restarting it. In this way, the refrigerant will be able to re-stabilise.
USE OF TIMER
Timer for switching on the unit
The air conditioner has a function that allows the unit to be switched on at a set time.
Press the POWER button to switch on the unit
Use the MODE button to select cooling, dehumidify or ventilator
Use the speed button to set the speed to High, Medium or Low
Use the ADJUST/ARROWS keys to select the correct temperature for the area in which the air conditioner is
located.
Now press the POWER button to switch the unit off
Press TIMER and using the ADJUST/ARROWS keys select the number of hours after which the unit is to be
switched on.
Timer for switching off the unit
The unit has a function that allows the unit to be switched off at a set time.
Press the POWER button to switch on the unit
Use the MODE button to select cooling, dehumidify or ventilator
Use the speed button to set the speed to High, Medium or Low
Use the ADJUST/ARROWS keys to select the correct temperature for the area in which the air conditioner is
located.
Press TIMER to switch on the timer and press ADJUST/ARROWS to set the number of hours until the unit is
to be switched off.
DRAINING OF WATER
In principle, all the water should be drained away via the air outlet by the ingenious evaporation system. If
the unit is operating in a very damp room, however, the reservoir will fill up more quickly than the water is
able to evaporate. In this case the unit will switch off so that the reservoir does not overflow. You can then
empty the unit via the drainage pipe at the rear. Don’t forget to re-tighten the drain plug when you have
finished.
GB
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Holland Electro Oslo 8000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Holland Electro Oslo 8000 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info