30194
7
Zoom out
Zoom in
Previous page
1/8
Next page
INSTALLATION
When installing the radio system to the model, please follow the detailed instructions for the
model kit.
A.Normal Installation (non BEC)
If you are using the regular mechanical speed control that usually comes with the model
kit, you will need both servos, and the battery harness that comes with the radio set.
Incidentally this is the installation method for the engine equipped model as well.
B.ESC installation (Electronic Speed Control)
You may wish to use an ESC in place of the mechanical speed control and throttle servo.
This will allow more precise control as well as less power consumption. Please note that
most ESC’s are already equipped with BEC so you can simply plug into channel two of
the receiver.
Installation diagram fig 7
HELPFUL HINT
A.BATTERY
Always take extra care that all the batteries in the radio set are fully charged (NiCad) or
fresh (Dry) when operating you radio. Otherwise the receiver range will substantially be
reduced and lose control thereby damaging your model and or people. When you re-
charge your transmitter NiCads with a charger jack, be careful of its polarity. The inner
contact should be positive (+), the outer negative (-). For your convenience, we recom-
mend our genuine overnight charger. CG-22(220V0 or CG-25(110V).
B.ANTENNA
Both the transmitter and the receiver antenna must be fully extended when in use. Be
careful that you do not cut off the excess receiver antenna wire or bundle it. This will
severely cut down on the operating range.
C.XTAL CHANGE
When changing the frequency to another channel, make sure that you match the trans-
mitter to the receiver channel. Also you must make sure that they are replaced with only
genuine Hitec single conversion FM xtals as not all xtal makes are compatible with each
other. Also remember that you can change frequencies only within the same frequency
band, which means you cannot change to 72MHz from 75MHz. (Also in the US, you
may not be allowed to change the transmitter xtal).
NORMAL INSTALLATION
E.S.C. INSTALLATION
7.2V ~ 8.4V
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hitec RANGER_IIFM at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hitec RANGER_IIFM in the language / languages: English as an attachment in your email.

The manual is 0,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info