Manual Hitec RANGER_IIFM (page 5 of 8) (English)

30194

Zoom out

Zoom in

1/8

2) Open the battery compartment at the back of the transmitter by pressing the cover down and

toward the bottom. (See fig 2)

3) Load batteries into the slots paying close attention to the polarity. (See fig 2)

4) Replace the battery cover and turn the power “ON” to see if the indicating arrow will move up. If

the batteries are fresh, the indicating arrow will move to the far right side but if the arrow is in the

low power or lower part of the yellow zone, you had better replace the batteries or recharge your

NiCad batteries. (See fig 3)

Loading Battery fig 2

Power indicating fig 3

BATTERY COVER

PRESS DOWN AND

TOWARD BOTTOM

8 AA SIZE BATTERY

BE CAREFUL TO LOAD

BATTERIES IN THE

RIGHT DIRECTION

Full power: White zone

Medium power: Yellow zone

Low power: Red zone

B. OPERATION CHECK

1) Gently plug the switch harness and servo connectors into the proper slots of the receiver. The

connectors are polarized, thus, should fit only one-way. If they will not go in one-way, reverse it

and see if it will plug in. Never use excessive force to plug in connectors. (See fig 1).

2) Turn the transmitter power switch “ON” first, then the receiver switch. Always remember to turn

the transmitter on the transmitter before you turn the receiver on, otherwise your receiver may

receive other interfering signals from other radio sources and jitter.

3) Check to see if the servos move when you control the sticks. Move the trim lever to the center

position. (See fig 4)

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Hitec RANGER_IIFM in the language / languages: English as an attachment in your email.

The manual is 0,36 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Hitec RANGER_IIFM Manual

Product: