Manual Hitachi UC3SML (page 5 of 45) (English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish)

571403

Zoom out

Zoom in

1/45

English

Model UC3SML

Charging voltage 3.6 V

Weight 0.2 kg

SPECIFICATION

CHARGER

APPLICATION

For charging the HITACHI BATTERY EBM315.

CHARGING

Before using the power tool, charge the battery as

follows.

1. Insert the charger connecting plug into the connecting

socket of the charger (Fig. 1)

2. Connect to the power source

When using the AC adapter

Plug the AC adapter into the power outlet.

CAUTION

Do not use the electrical cord if damaged. Have

it repaired immediately.

When using the cigarette lighter connecting plug

⅜ Secure the battery charger in place in the car.

Use the strap supplied with the battery charger to

fasten the battery charger in place and prevent it

from moving inadvertently. (See Fig. 2)

CAUTION

Do not place the battery charger or battery under

the driver’s seat. Secure the battery charger in

place to prevent it from moving inadvertently

as this may lead to an accident.

⅜ Insert the cigarette lighter connecting plug into the

cigarette lighter socket.

If the plug is loose and falls out of the cigarette

lighter socket, repair the socket. As the socket may

be faulty, you are recommended to contact your

local car dealer. Continued use of the socket may

result in an accident due to overheating.

3. Insert the battery in the charger

Position the battery so that the nameplate faces

toward the nameplate of the charger and press in

the battery until it comes into contact with the

bottom plate (See Fig. 1).

Inserting the battery will turn on the charger (the

pilot lamp lights up).

CAUTION

If the pilot lamp does not light up, pull out the

power cord from the receptacle and check the

battery mounting condition.

The pilot lamp goes off to indicate that the battery

is fully charged.

4. Disconnect battery charger from the receptacle or

cigarette lighter socket

5. Hold the charger firmly and pull out the battery

NOTE

Be sure to pull out the battery from the charger

after use, and then keep it.

Regarding electric discharge in case of new batteries,

etc.

As the internal chemical substance of new batteries

and batteries that have not been used for an

extended period is not activated, the electric

discharge might be low when using them the first

and second time. This is a temporary phenomenon,

and normal time required for recharging will be

restored by recharging the batteries 2-3 times.

How to make the batteries perform longer.

(1) Recharge the batteries before they become

completely exhausted.

When you feel that the power of the tool becomes

weaker, stop using the tool and recharge its battery.

If you continue to use the tool and exhaust the

electric current, the battery may be damaged and

its life will become shorter.

(2) Avoid recharging at high temperatures.

A rechargeable battery will be hot immediately after

use. If such a battery is recharged immediately after

use, its internal chemical substance will deteriorate,

and the battery life will be shortened. Leave the

battery and recharge it after it has cooled for a

while.

Fig. 2

NOTE: The recharging time may vary according to the

ambient temperature.

Table 1 Recharging time (approx. min.) at 20°C

Battery

voltage

(V)

Battery capacity (Ah)

1.5 Ah

3.6 V EBM315 60 min.

CAUTION

If the battery is heated due to direct sunlight,

etc., just after operation, the charger pilot lamp

may not light. At that time cool the battery first,

then start charging.

⅜ Regarding recharging time

Table 1 shows the recharging time required

according to the type of battery.

01Eng_UC3SML_WE_NE 9/5/07, 15:084

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Hitachi UC3SML in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 2,71 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Hitachi UC3SML Manual

Product: