537846
44
Zoom out
Zoom in
Previous page
1/60
Next page
43
Replacing the lamp
To prepare a new lamp, contact your dealer and tell the lamp type number.
Type number: DT01461
WARNING
The projector uses a high-pressure mercury glass lamp.
The lamp can break with a loud bang, or burn out, if jolted or scratched, handled while hot,
or worn over time. Note that each lamp has a different lifetime, and some may burst or
burn out soon after you start using them.
Hg - Lamp contains mercury. Manage in accordance with local disposal
laws. See www.lamprecycle.org
To reduce the risk of electrical shock, always turn the projector off and disconnect the
power cord before changing the lamp.
To reduce the risk of severe burns, allow the projector to cool for at least 45 minutes
before replacing the lamp.
To reduce the risk of injuries to fingers and damage to internal components, use caution
when removing lamp glass that has shattered into sharp pieces. Before replacing the
lamp, clean the lamp compartment and dispose of cleaning materials. Be careful of sharp
edges in the lamp compartment. Wash hands after lamp replacement.
If the lamp should break (it will make a loud bang when it does), ventilate the room well,
and make sure not to inhale the gas or fine particles that come out from the projector's
vent holes, and not to get them into your eyes or mouth.
Only certified lamps are tested with this projector. Use of other lamps may cause electrical
shock and fire.
Be sure to place the projector on a flat surface to replace the lamp.
1. Turn the power off and disconnect the
power cord from the wall socket. If the
lamp is hot, avoid burns by waiting for
approximately 45 minutes until the lamp
has cooled.
2. Prepare a new lamp. If the projector is
mounted in a high position, or if the lamp
has broken, also ask the dealer to replace
the lamp.
3. Loosen the screw of the lamp cover. Refer
to the right figure to identify the screw.
4. Remove the lamp cover from the projector.
WARNING
Do not turn the power on with the lamp cover
removed.
Do not insert your fingers between the lamp
and the projector. It may cause injuries.
1
2
44


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hitachi CP-DX300 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hitachi CP-DX300 in the language / languages: English as an attachment in your email.

The manual is 3,85 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info