742724

Hikoki N 14DSL Manual

18
Zoom out
Zoom in
Previous page
1/200
Next page
13. Beware of the tool’s kickback.
Do not approach the top of the tool with your head etc.
during operation. This is dangerous because the tool
may recoil violently if the staple currently being driven
in comes into contact with a previous staple or a knot in
the wood.
14. Take care when stapling thin boards or the corners
of wood.
When stapling thin boards, the staples may pass right
through, as may also be the case when stapling the
corners of wood due to deviation of the staples. In
such cases, always make sure that there is no one (and
nobody’s hands or feet; etc.) behind the thin board or
next to the wood you are going to staple.
15. Simultaneous staping on both sides of the same
wall is dangerous.
Under no circumstances should stapling be performed on
both sides of a wall at the same time. This would be very
dangerous since the staples might pass through the wall
and thus cause injuries.
16. Do not use the power tool on scaff oldings,
ladders.
The power tool shall not be used for specifi c application
for example:
– when changing one driving location to another
involves the use of scaff orldings, stairs, ladders or
ladder alike constructions, e.g. roof laths,
– closing boxes or crates,
– fi tting transportation safety systems e.g. on
vehicles and wagons
17. Do not disconnect the battery with your fi nger on
the trigger.
If you disconnect the battery with your fi nger on
the trigger, the next time the battery is connected,
there is a danger that the power tool will fi re a staple
spontaneously, or operate incorrectly.
18. Disconnect the battery and take out any staples
left in the magazine after use.
Disconnect tool from battery before doing tool
maintenance, cleaning a jammed fastener, leaving
work area, moving tool to another location, or after use.
It is very dangerous for a staple to be fi red by mistake.
19. When removing a staple which has become stuck,
make sure to fi rst of all disconnect the battery.
When removing a staple which has become stuck in
the staple outlet, fi rst of all make sure to disconnect the
battery.
Accidental fi ring of the staple could be very dangerous.
20. To avoid hazards caused by falling staples,
never open the magazine with the device facing
downward while loading staples.
21. When cleaning the power tool, do not use gasoline
or other infl ammable liquids.
If vapour from an infl ammable liquid gets into the power
tool, there is a danger that sparks produced when stapling
etc. may cause an explosion.
22. Always charge the battery at a temperature of
0 – 40°C.
A temperature of less than 0°C will result in over
charging which is dangerous. The battery cannot be
charged at a temperature greater than 40°C.
The most suitable temperature for charging is that of
20 – 25°C.
23. Do not use the charger continuously.
When one charging is completed, leave the charger for
about 15 minutes before the next charging of battery.
24. Do not allow foreign matter to enter the hole for
connecting the rechargeable battery.
25. Never disassemble the rechargeable battery and
charger.
26. Never short-circuit the rechargeable battery.
Short-circuiting the battery will cause a great electric
current and overheat. It results in burn or damage to the
battery.
27. Do not dispose of the battery in fi re.
If the battery burnt, it may explode.
28. Do not insert object into the air ventilation slots of the
charger.
Inserting metal objects or infl ammables into the charger
air ventilation slots will result in electrical shock hazard
or damaged charger.
29. Bring the battery to the shop from which it was
purchased as soon as the post-charging battery life
becomes too short for practical use. Do not dispose of
the exhausted battery.
30. Using an exhausted battery will damage the charger.
CAUTION ON LITHIUM-ION BATTERY
To extend the lifetime, the lithium-ion battery equips with
the protection function to stop the output.
In the cases of 1 to 3 described below, when using this
product, even if you are pulling the switch, the motor may
stop. This is not the trouble but the result of protection
function.
1. When the battery power remaining runs out, the motor
stops.
In such case, charge it up immediately.
2. If the tool is overloaded, the motor may stop. In this
case, release the switch of tool and eliminate causes of
overloading. After that, you can use it again.
3. If the battery is overheated under overload work, the
battery power may stop.
In this case, stop using the battery and let the battery
cool. After that, you can use it again.
Furthermore, please heed the following warning and
caution.
WARNING
In order to prevent any battery leakage, heat generation,
smoke emission, explosion and ignition beforehand,
please be sure to heed the following precautions.
1. Make sure that swarf and dust do not collect on the
battery.
○ During work make sure that swarf and dust do not fall
on the battery.
○ Make sure that any swarf and dust falling on the power
tool during work do not collect on the battery.
○ Do not store an unused battery in a location exposed to
swarf and dust.
○ Before storing a battery, remove any swarf and dust
that may adhere to it and do not store it together with
metal parts (screws, nails, etc.).
2. Do not pierce battery with a sharp object such as a
nail, strike with a hammer, step on, throw or subject the
battery to severe physical shock.
3. Do not use an apparently damaged or deformed
battery.
4. Do not use the battery in reverse polarity.
5. Do not connect directly to an electrical outlets or car
cigarette lighter sockets.
6. Do not use the battery for a purpose other than those
specifi ed.
7. If the battery charging fails to complete even when a
specifi ed recharging time has elapsed, immediately
stop further recharging.
8. Do not put or subject the battery to high temperatures
or high pressure such as into a microwave oven, dryer,
or high pressure container.
9. Keep away from fi re immediately when leakage or foul
odor are detected.
10. Do not use in a location where strong static electricity
generates.
11. If there is battery leakage, foul odor, heat generated,
discolored or deformed, or in any way appears abnormal
during use, recharging or storage, immediately remove
it from the equipment or battery charger, and stop use.
18
English
0000Book_N14DSL.indb 180000Book_N14DSL.indb 18 2020/04/17 14:16:222020/04/17 14:16:22
… 18 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hikoki N 14DSL at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hikoki N 14DSL in the language / languages: All languages as an attachment in your email.

The manual is 5,59 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info