700154
20
Zoom out
Zoom in
Previous page
1/28
Next page
20
ENG|OPERATIONAL INSTRUCTIONS
1312
FUNCTIONS AND OPERATIONAL CONTROLS
12
The INPUT LEVEL MODE switch sets the operation mode of the LINE IN RCA connectors. In pushed position (LOW), the LINE
IN is suited for pre-amplifier signal (low level signals, pre-amplifier outputs from the head unit). In the non-pushed position (HI)
the LINE IN connectors are suited for high level signals from the speaker outputs of the headunit.
13
AUTO TURN ON
If your headunit doesn’t provide a separate remote turn on wire (like described on page 18/#2) and has no pre-amplifier low level
RCA outputs, follow these instructions:
Bring the AUTO TURN ON switch to position ON to activate the auto turn on function. This function only works, if the push button
INPUT LEVEL MODE is in HI position and highlevel inputs (speaker outputs from the headunit) are connected at the LINE IN.
Please check the regarding notes below.
The amplifier detects now by the so called ”DC Offset” (a voltage increase to 6 volts on the high level speaker outputs) if the
headunit is turned on and the amplifier turns automatically on. As soon as the headunit is turned off, the amplifier shuts down
automatically after approx.one minute.
NOTE: The AUTO TURN ON usually works with 90% of all headunits, because they are equipped with the ”High Power” outputs.
Only with a few older headunits the AUTO TURN ON function is not applicable.
The port of the remote connector of the amplifier (page 18/#2, REM) can now be used also to turn on additional other amplifiers.
Connect the REM ports of the amplifiers and ensure, that the other amplifier’s AUTO TURN ON function is deactivated.
+
To connect the high level speaker cables of the headunit
follow these instructions:
Crimp and solder the ends of the loudspeaker cables of the
headunit with common RCA connectors (separately available)
and connect them with LINE IN of the amplifier.
You can simplify the installation, if you use the separately available
hi-to-lo adaptors HF-HLA from HiFonics (see page 25).
Shield
To the LINE IN on the Amp
Speaker Cables
Core Conductor
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hifonics TSi1500-I at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hifonics TSi1500-I in the language / languages: English, German as an attachment in your email.

The manual is 2,15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info