Manual Hifonics TSi1000-I (page 21 of 28) (English, German)

700153

Zoom out

Zoom in

1/28

OPERATIONAL INSTRUCTIONS|ENG

INTERCONNECTION

• Connect the RCA lineouts of the headunit with the RCA jacks LINE IN of the amplifier with appropriate high-value RCA cables.

If your headunit is equipped with a additional subwoofer lineout (SUB OUT), it is recommended to use this lineout.

• Connect the subwoofer with the speaker outputs (SPEAKER OUTPUTS + / -) by using appropriate wires.

• Ensure by any means, that the total impedance load of subwoofer is not lower than 1 ohm. Too low impedance cause high

temperature and will shut down the amplifier operation.

• Always ensure the correct polarity of the speakers. The interchange of plus and minus cause total loss of bass playback and could

damage the speakers.

MODE SWITCH

• The MODE switch must be in Position MASTER.

LEVEL CONTROLLER

• Turn the LEVEL controller of the amplifier to the MIN. position.

• Turn the volume controller of the headunit to 80 - 90% of its full setting.

• Turn the LEVEL controller clockwise until you hear some distortion.

• Then turn back the LEVEL controller slightly until you hear a cleaner sound.

BOOST CONTROLLER

• The BOOST controller adjusts the bass enhancement between 0db and +12dB @ 50 Hz.

• A too high bass boost may cause clipping/distortion and damage on the loudspeakers and also may harm your hearing abilities.

Use this controller carefully!

LPF (LOW PASS FILTER) CONTROLLER

• The LPF controller adjusts the cut-off point of the frequency range to above. The cut-off frequency is continuously

adjustable from 40 Hz to 150 Hz.

SUB SONIC CONTROLLER

• The SUB SONIC controller (Subsonicfilter) limits the ultralow and not hearable frequencies of the audiosignal to below, to avoid a

mechanical and electrical overloading on the subwoofer. The cut-off frequency is adjustable from 15 to 55 Hz and depends on the size

of the subwoofer.

PHASE CONTROLLER

• The PHASE controller allows to adjust the phasing between 0° and 180°.

Thereby you are able to adjust the subwoofer perfect to the vehicle’s acustics.

REMOTE BASS LEVEL CONTROLLER BLC-TSi

• The enclosed remote BASS LEVEL Controller BLC-TSi adjusts the bass-level e.g. from the driver’s seat.

Please use only the enclosed controller and cable.

INTERCONNECTION EXAMPLE Low Pass-Mode (Standard Subwoofer Operation)

BLC-TSi

Connect stereo RCA output

(R/L or SUB OUT)

of the headunit with

LINE IN R/L of the amplifier

R L

Subwoofer

1 – 8 Ohms

Switch setting:

MASTER

An additional subwoofer can be connected to the non-occupied

speaker outputs. In this case ensure a impedance of 2 - 8 ohms

per subwoofer.

NOTE!

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Hifonics TSi1000-I in the language / languages: English, German as an attachment in your email.

The manual is 2,15 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Hifonics TSi1000-I Manual

Product: