700159
18
Zoom out
Zoom in
Previous page
1/24
Next page
18
INTERCONNECTION EXAMPLE LOWPASS-MODE: 1 x Subwoofer
ENG|OPERATIONAL INSTRUCTIONS
INTERCONNECTION
Connect the RCA lineouts of the headunit with the RCA jacks LINE IN of the amplifier with appropriate high-value RCA cables.
If your headunit is equipped with a additional subwoofer lineout (SUB OUT), it is recommended to use this lineout.
Connect the subwoofer with the speaker outputs (SPEAKER OUTPUTS + / -) by using appropriate wires.
Ensure by any means, that the total impedance load of subwoofer is not lower than 1 ohm. Too low impedance cause high
temperature and will shut down the amplifier operation.
Always ensure the correct polarity of the speakers. The interchange of plus and minus cause total loss of bass playback and could
damage the speakers.
XOVER MODE SWITCH
• The XOVER MODE-Switch must be in Position LPF/BPF.
LEVEL CONTROLLER
• Turn the LEVEL controller of the amplifier to the MIN. position.
• Turn the volume controller of the headunit to 80 - 90% of its full setting.
• Turn the LEVEL controller clockwise until you hear some distortion.
• Then turn back the LEVEL controller slightly until you hear a cleaner sound.
BOOST CONTROLLER
• The BOOST controller adjusts the bass enhancement between 0db and +12dB @ 50 Hz.
• A too high bass boost may cause clipping/distortion and damage on the loudspeakers and also may harm your hearing abilities.
Use this controller carefully!
LPF (LOW PASS FILTER) CONTROLLER
The LPF controller adjusts the cut-off point of the frequency range to above. The cut-off frequency is continuously
adjustable from 50 Hz to 250 Hz.
HIGHPASS/SUB SONIC CONTROLLER
The HPF controller (Subsonicfilter) limits the ultralow and not hearable frequencies of the audiosignal to below, to avoid a
mechanical and electrical overloading on the subwoofer. The cut-off frequency is adjustable from 10 to 100 Hz and depends on the size
of the subwoofer.
PHASE CONTROLLER
The PHASE controller allows to adjust the phasing between 0° and 180°.
Thereby you are able to adjust the subwoofer perfect to the vehicle’s acustics.
REMOTE BASS LEVEL CONTROLLER BLC-TR
The enclosed remote BASS LEVEL Controller BLC-TR adjusts the bass-level e.g. from the driver’s seat.
Please use only the enclosed controller and cable.
BLC-TR
Connect RCA output (L/R) of the
headunit with LINE IN of the amplifier
R L
Subwoofer
2 – 8 Ohm
Position XOVER MODE:
LPF/BPF
An additional subwoofer can be connected to the non-occupied
speaker outputs. In this case ensure a impedance of 4 - 8 ohms
per subwoofer.
NOTE!
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hifonics Triton I at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hifonics Triton I in the language / languages: English, German as an attachment in your email.

The manual is 1,96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info