505731
8
Zoom out
Zoom in
Previous page
1/18
Next page
BRX5000.5 5-CHANNEL AMPLIFIER APPLICATIONS
6
5 channel discrete, one being mono low pass
Single Set of Stereo RCAs
- CH 3 / 4 X-OVER: FULL
You can use this configuration simply as 4 discrete full range channels, with a 5th
low pass channel. All of the crossovers are bypassed , except the LOW PASS on
channel 5. The 5 channels can also be utilized with an outboard active crossover,
Crossover frequency control checklist:
or with crossovers in head units or equalizers. This setup is common when your
- CH 1 / 2 HIGH PASS: N/A
headunit or crossover has 2 sets of full range RCA outputs and 1 set of mono
- CH 3 / 4 HIGH PASS: N/A
subwoofer outputs.
- CH 3 / 4 LOW PASS: N/A
- CH 5 LOW PASS: 80 Hz
Interconnect cable checklist:
Connect channel 1&2 inputs to the front output, channels 3&4 to the rear output,
Please note that these frequency points are suggestions only. Refer to the
and channel 5 to the mono subwoofer output of a head unit or in dash equalizer.
loudspeaker manufacturer specifications and the section “Setting up systems
The LOW PASS filter on channel 5 will be in tandem with that of the source. You
after installation for best performance”
can either set it to the same frequency for a steeper rolloff, or set it to a higher
frequency to minimize it’s effect. By the same reasoning, you could switch
Level control checklist:
channels 1,2,3&4 high pass crossovers in for steeper high pass slopes.
- Refer to the section “Setting up systems after installation for best performance”
Switch setting checklist:
Minimum final loudspeaker impedances:
INPUT MODE: 5CH DISCRETE
- 2 Ohms per channel for channels 1-4
- CH 1 / 2 X-OVER: FULL
We will use the same basic setup on the speaker and subwoofer connections as
Crossover frequency control checklist:
above to illustrate an installation that only has 1 set of stereo RCA’s to connect to
this amplifier. By switching the amplifier to 3CH on the INPUT MODE, you now
- CH 1 / 2 HIGH PASS: N/A
provide signal to all channels on the amplifier.
- CH 3 / 4 HIGH PASS: N/A
- CH 3 / 4 LOW PASS: N/A
Interconnect cable checklist:
- CH 5 LOW PASS: 80 Hz
Connect Stereo Left and Right RCA’s from headunit to CH1&2 RCA Inputs.
Minimum final loudspeaker impedances:
Switch setting checklist:
- 2 ohm per channel in stereo mode
INPUT MODE: 2CH
- 4 ohm per mono bridged pair
- CH 1 / 2 X-OVER: FULL
- 2 ohm on channel 5
- CH 3 / 4 X-OVER: FULL
POWER INPUT
POWER INPUT
GND REM BATT+12V
GND REM BATT+12V
1CH 2CH
1CH 2CH
3CH 4CH 5CH
3CH 4CH 5CH
+ - + - + - + - + -
+ - + - + - + - + -
BRIDGED
BRIDGED
BRIDGED
BRIDGED
BRUTUS
BRUTUS
LINE INPUT CH1/2 X-OVER HI PASS LEVEL HI PASS CH3/4 X-OVER LOW PASS LEVEL
10Hz 1.5kHz 6V 0.2V 10Hz 1.5kHz 30Hz 150Hz 6V 0.2V
30Hz 150Hz 0dB 10dB 6V 0.2V POWER
REMOTE LOW PASS BASS EQ LEVEL CH5 MODE
PROTECT
Ch2
Ch5
Ch4
Ch3Ch1
HI FULL
HI FULL LP
2CH 4CH 5CH
LINE INPUT CH1/2 X-OVER HI PASS LEVEL HI PASS CH3/4 X-OVER LOW PASS LEVEL
10Hz 1.5kHz 6V 0.2V 10Hz 1.5kHz 30Hz 150Hz 6V 0.2V
30Hz 150Hz 0dB 10dB 6V 0.2V POWER
REMOTE LOW PASS BASS EQ LEVEL CH5 MODE
PROTECT
Ch2
Ch5
Ch4
Ch3Ch1
HI FULL
HI FULL LP
2CH 4CH 5CH
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hifonics Brutus BRX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hifonics Brutus BRX in the language / languages: English as an attachment in your email.

The manual is 6,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info