741208
6
Zoom out
Zoom in
Previous page
1/64
Next page
6
EN
Preparations before using for the first time
• Remove all protective packaging and wrapping.
Check to make sure the appliance is undamaged.
In case of incomplete delivery and damages.
Please contact supplier (See == > Warranty).
Clean the appliance before use (See == > Clean-
ing and Maintenance).
Make sure the appliance is completely dry.
Place the appliance on a horizontal, stable and
heat resist surface that is safe against water
splashes.
Ensure that there is sufficient ventilation. Keep a
minimum distance of 15cm around the appliance
bottom of cookware
Do not place the appliance in close proximity to
devices which are sensitive to disturbances by
magnetic sources (e.g. radios, tape decks).
Note: Due to manufacturing residues, the appli-
ance may emit a slight odor in the first few cycles.
This is normal and does not indicate any defect or
hazard. Make sure the appliance is well ventilated.
Suitable cooking equipment
Suitable Not suitable
Bottom of cookware Flat bottom
Curved, uneven, rounded bottom
Material Cookware with iron, cast iron, magnetic stain-
less steel or enamelled iron bottom.
Cookware with ceramic, glass, copper,
bronze, or aluminium bottom.
Diameter of the bottom Between 12 cm and 26 cm. Less than 12 cm or more than 26 cm.
Type of cookware Cookware with a bottom thickness over 1.5 mm. Completely closed containers or cans.
Note: Using a pan or pot that’s not suitable for induction cooking may damage the appliance.
Operation
Place a suitable cookware at the centre of the
heating surface of the appliance. (See --> Suita-
ble cookware for the appliance).
Note: Do not place empty cookware as this may
damage the cookware.
Connect the power plug to a suitable electrical
supply outlet.
Then, switch ON the appliance by turning the
knob (2) in clockwise direction.
“ON” will be shown instantly on the display (1).
Next, choose the power level by turning the knob
(2) clockwise.
Minimal setting is 500W which increases in steps
of 100 W to the maximum setting of 3500 W for
item 239780 or 3000W for item 239315.
Now, the appliance starts heating operation. The
set power will be shown on the display (1) during
cooking.
After cooking finished, you can turn off the ap-
pliance at any time by turning the knob (2) an-
ti-clockwise. “OFF” will be shown on the display
(1) for few seconds and then go off.
Note:
1). After an extended period of operation, it is nor-
mal for the cooling fan inside to continue run-
ning in OFF mode for some time. Before unplug
the appliance, wait until the cooling fan stops
running.
2). The appliance’s surface is still hot even after
switch to OFF mode. Please wait the appliance
completely cool down before touching or clean-
ing.
3). If no cookware is placed on the heating surface
after switch ON, it will turn to OFF mode auto-
matically within 1 min.
4). If no any button on the control panel is pressed
during operation for 2 hours, the appliance will
then switch to OFF mode automatically.
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hendi 239780 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hendi 239780 in the language / languages: English, German, Dutch, French, Italian, Polish as an attachment in your email.

The manual is 0,76 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info