535968
8
Zoom out
Zoom in
Previous page
1/32
Next page
8
Dear HECO Customer,
Congratulations on your ne new loudspeakers and thank you very much for choosing HECO! You have made an excellent
choice. The high-quality speakers produced by HECO are renowned all over the world.
Please study the instructions and information below carefully before using your new loudspeakers.
IMPORTANT SAFETY PRECAUTIONS
Please read through the instruction manual carefully before starting to use the device. This manual contains important
information concerning operation and safety aspects. It is imperative you observe all of the information. Keep the
manual in a safe location.
WARNING NOTICES: All of the warning symbols on the speaker, accessories and in the instruction manual itself must
be adhered to.
EXPOSURE TO HEAT: Only operate the speakers and accessories in a temperature range from 10°C to 40°C.
The speaker should not be positioned near heat sources (heaters, ovens, radiant heaters, naked ames, etc.). When
setting up close to an amplier a minimum distance of 10 cm must be maintained.
The aluminium plate of the amplier at the rear of the device serve to cool the built-in amplier; for this reason, they
must not be covered (e.g. by a curtain).
EFFECT OF MOISTURE: The speaker should not be exposed to dripping or splash water. Neither should it be used to
support vases or other containers lled with liquid. Do not expose the speaker to water or high levels of humidity. There
is a danger of electric shock. In the event of contact with moisture or liquids remove the mains adapter immediately.
FOREIGN MATERIAL: Ensure that no foreign material enters through the speaker openings and into the interior. This
could trigger short circuits and even result in electric shock and re.
CLEANING: Please use a soft, dry cloth with no cleaning agents, sprays or chemical solvents, as these could damage
the surfaces.
ELECTRICAL CONNECTION: Please note the voltage levels on the information signs. The mains adapter for the
speaker should only be operated with the voltage and frequency values specied on the signs.
LIGHTNING PROTECTION/PREVENTIVE MEASURES: If the device is not going to be used for a prolonged period
(e.g. when on holiday), it should be disconnected from the mains by removing the plug. The device should also be
disconnected from the mains in the event of a thunderstorm. Doing this will prevent damage caused by lightning and
overvoltage.
MAINS CABLE: The mains cable must always be suitable for operation and it should only ever be laid out in a manner
that prevents it from being trodden on. It should not be pinched by objects either, as this can damage the cable. When
using plugs and power strips it must be ensured that the cable is not kinked at the point where it emerges from the
socket. Do not connect or remove the mains cable with damp hands.
OVERLOAD: Sockets, power strips and extension cables should not be overloaded. If an overload occurs, there is a
risk of electric shock and re.
SETTING UP: Please read the installation instructions.
The speaker should only be positioned on a solid surface and not on moving base frames, otherwise there is a risk of
injury.
DAMAGE THAT MUST BE RECTIFIED BY A SPECIALIST:
If any of the following damage occurs, disconnect the device from the mains immediately and contact a specialist to
conduct the repair work:
Damage to the mains cable or the mains plug. A damaged cable should not be repaired, but must be replaced.
If moisture or water has entered the device or foreign objects have fallen into the device.
If the speaker has fallen and the housing is damaged.
If the device does not work properly, even though all of the information in the instruction manual has been observed.
Only those subsequent alterations approved by the manufacturer may be conducted.
Only original spare parts should be used for repair.
After conducting any repairs the safety of device should be checked to ensure it is functioning correctly and safely.
Repairs must always be conducted by qualied specialists, as you might otherwise be exposed to dangerous high voltage
levels or other hazards.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Heco ASCADA 300 BTX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Heco ASCADA 300 BTX in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 0,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info