801917
15
Zoom out
Zoom in
Previous page
1/98
Next page
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
When installing and using this electrical equipment, basic safety precautions should always be
observed including the following. Failure to adhere to the safety warnings below may result in
severe injury, death or property damage.
Closely supervise children and pets at all times to ensure
they do not play with the cleaner – it is not a toy.
Ensure that children do not attempt to access the cleaner
while it is operating.
This appliance is not intended for use by persons with
reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by
a person responsible for their safety.
DO NOT PERMIT CHILDREN TO USE THIS PRODUCT.
NEVER swim with the cleaner in the pool.
Always disconnect and completely remove the cleaner
before entering the pool.
All electrical wiring MUST be in conformance with applicable
local codes and regulations (See table at end of document).
Always follow local code requirements. Hazardous voltage
can shock, burn, and cause death or serious property damage.
The cleaner should only be used with the provided cleaner
control unit, which supplies only Safety Extra Level Low
Voltage (SELLV) to the cleaner.
The cleaner control unit shall be located at least 3.5 m (11.5 ft.)
from the closest edge of the pool.
To reduce the risk of electric shock, DO NOT USE AN
EXTENSION CORD to connect control unit to electrical
outlet. This could create a safety hazard and/or damage
to the cleaner. Provide a properly located electrical outlet
per local building codes.
This is the safety-alert symbol. When you see this symbol on your equipment or in this manual, look
for one of the following signal words and be alert to the potential for personal injury.
WARNING warns about hazards that could cause serious personal injury, death or major
property damage and, if ignored, presents a potential hazard.
CAUTION warns about hazards that will or can cause minor or moderate personal injury
and/or property damage and, if ignored, presents a potential hazard. It also makes consumers
aware of actions that are unpredictable and unsafe.
READ AND FOLLOW ALL INSTRUCTIONS
WARNING - RISK OF INJURY
WARNING - RISK OF ELECTRICAL SHOCK
WARNING - RISK OF ELECTRICAL SHOCK
Disconnect the cleaner control unit from the electrical
outlet before carrying out any user maintenance. Before
working on any equipment, disconnect control unit
from the equipment.
Do not bury cable. Do not operate the cleaner with a
damaged cable. If the control unit power cord is damaged,
it must be replaced by the manufacturer, service agent, or
similarly qualied persons in order to avoid a hazard.
In the United States and Canada, the cleaner control unit
must be connected only to a supply circuit protected by a
ground-fault circuit-interrupter (GFCI). Contact a qualied
electrician if you cannot verify that the circuit is protected
by a GFCI. This GFCI should be tested on a routine basis.
To test the GFCI, push the test button. The GFCI should
interrupt power. Push reset button. Power should be
restored. If the GFCI fails to operate in this manner, the
GFCI is defective. If the GFCI interrupts power to the
cleaner control unit without the test button being pushed,
a ground current is owing, indicating the possibility of
an electrical shock. Do not use the cleaner control unit.
Disconnect the cleaner control unit and contact the
manufacturer for assistance.
In Europe, Australia and New Zealand, the cleaner control
unit must be supplied through a residual current device
(RCD) having a rated residual operating current not
exceeding 30 mA. Contact a qualied electrician if you
cannot verify that the circuit is protected by a RCD.
Never allow the plug to enter the water.
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hayward AquaVac 650 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hayward AquaVac 650 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 12.48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info