801892
27
Zoom out
Zoom in
Previous page
1/100
Next page
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Page 10 of 16 AquaRite® Pro LS Rev. D
If ORP Auto Sensing is not used
Super Chlorinate
22 hours
Adjust Super Chlorinate period (1-96 hours)
Move to previous/next menu item
Use the Super Chlorinate feature when there is an unusually high bather load, a large amount of rain, a
cloudy water condition, or any other condition that requires a large amount of chlorine to be introduced
to the pool. Note that the filter pump must be running for the entire time during the Super Chlorinate
period. Set the actual time based on the size of the pool; larger pools require more hours, smaller pools
require less
If AQL-CHEM is used
pH Calibration
Wizard + to enter
Push to access pH Calibration Wizard
Move to previous/next menu item
Use this Wizard to calibrate the AQL-CHEM’s pH probe. This requires a manual pH test of the pool
water using a dependable red phenol test kit (see AQL-CHEM manual).
If AQL-CHEM is used
Clean Probe Wizard
+ to enter
Push to access Clean Probe Wizard
Move to previous/next menu item
Use this Wizard to clean the AQL-CHEM’s ORP and pH probes. The probes must be clean and free
from oil, chemical deposits and contamination to function properly. Slow response, increased need to
calibrate, and inconsistent readings are indications that the probes need to be cleaned (see AQL-CHEM
manual).
Toggle between Metric and English
Move to previous/next menu item
Units
Metric
The AquaRite Pro LS can display temperature and units in Metric (ºC and g/L) or English (ºF and PPM).
Make the desired selection here.
Toggle between Always On and On for 60 sec.
Move to previous/next menu item
Display Light
On for 60 sec
This function controls the backlight on the display. Select between "Always On" and "On for 60 seconds".
If “On for 60 seconds” option is selected, then the backlight will automatically turn off 60 seconds after
the last key is pressed and will stay off until next time a key is pressed.
Toggle between Enabled (default) and Disabled Beeper
Move to previous/next menu item
Beeper
Enabled
When “Enabled”, the keypad will beep every time a key is pressed. If this audible indication is not
desired, select “Disabled”.
Initiate reset of all conguration parameters
Move to previous/next menu item (cong. not reset)
Reset Config. to
Default Press +
Reset all conguration parameters
Move to previous/next menu item (cong. not reset)
Are you sure?
+ to proceed
Config. reset
Confirmed Move to previous/next menu item
Use this function to erase all previous system configuration and reset all configuration parameters back
to the factory default values.
This function is NOT reversible, be careful
OPERATION
Assuming that the water chemical levels are in the recommended range, there are three factors that you can control
which directly contribute to the amount of chlorine the AquaRite Pro LS will generate:
1. filter run time each day (hours)
2. the desired output % setting or ORP setting (when using AQL-CHEM)
3. the amount of salt in the pool
The filter pump timer should be set so that entire volume of pool water passes through the filter each day. For pools with
high chlorine demand, the timer may have to be set longer to generate enough chlorine.
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hayward Aqua Rite Pro LS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hayward Aqua Rite Pro LS in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 3.96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info