Manual Harman Kardon HKTS 65BQ (page 10 of 12) (English)

534543

Zoom out

Zoom in

1/12

HKTS 65BQ

Operating Your Subwoofer (cont.),

and Specifications

Wireless Operation

When the wireless transmitter receives an audio signal from the source, it will immediately

turn on and its status LED will change to ashing green or solid green:

Green (ashing): Transmitter is on but has not established a link with the wireless

subwoofer

Green (solid): Transmitter is on and has already established a link with the wireless

subwoofer.

Red: Standby (no signal detected, transmitter off)

The transmitter will automatically enter the Standby mode after no audio signal is

detected from the source for approximately 10 minutes.

Wireless Code Settings

The Wireless Code selectors on the transmitter unit and subwoofer must be set to the

same position for the system to function correctly.

In the unlikely event that there is interference when operating the system, or if you

have more than one HKTS 220SUB operating, you may change the channel at which the

system operates. Set the Wireless Code selectors on one subwoofer’s transmitter module

and subwoofer to one of the other three positions.

You can also set up a maximum of two subwoofers to receive audio from a single

transmitter by setting the Wireless Code selectors on the transmitter and both of the

subwoofers to the same position.

Subwoofer Adjustments

Volume

Use the Subwoofer Level Control to set the subwoofer’s volume. Turn the knob clockwise

to increase the subwoofer’s volume; turn the knob counterclockwise to decrease the

subwoofer’s volume.

Notes on Setting Subwoofer Volume:

Sometimes the ideal subwoofer volume setting for music is too loud for lms, while the

ideal setting for lms is too quiet for music. When setting the subwoofer volume, listen to

both music and lms with strong bass content and nd a “middle ground” volume level

that works for both.

If your subwoofer always seems too loud or too quiet, you may want to place it in a

different location. See Speaker Placement: Subwoofer, on page 5, for more information.

Phase

The Phase switch determines whether the subwoofer’s piston-like action moves in and

out in phase with the satellite speakers. If the subwoofer were to play out of phase with

the satellite speakers, the sound waves from the satellites could cancel out sound waves

from the subwoofer, reducing bass performance and sonic impact. This phenomenon

depends in part on the placement of all the speakers in the room.

Although in most cases the Phase switch should be left in the “Normal” position, there

is no absolutely correct setting for the Phase switch. When the subwoofer is properly in

phase with the satellite speakers, the audio will be clearer, have maximum impact and

make percussive sounds like drums, piano and plucked strings sound more lifelike. The

best way to set the Phase switch is to listen to music that you know well and set the

switch in the position that gives drums and other percussive sounds maximum impact.

Bass Boost

When set to the “On” position, the Bass Boost switch enhances low-frequency

performance, resulting in bass with more impact, which you may prefer while watching

movies or listening to music. There is no harm in experimenting with this control. Setting

the switch to the “Off” position will return normal low-frequency performance to your

system.

Specifications

HKTS 65 System

Frequency response: 45Hz – 20kHz (–6dB)

SAT-TS60 Satellite Speakers

Midrange transducers: Dual 3" (75mm) honeycomb at-diaphragm

drivers, video-shielded

High-frequency transducer: 1" (25mm) CMMD

Lite dome, video-shielded

Suggested amplier power range: 20 – 150 watts

Nominal impedance: 8 ohms

Sensitivity (2.83V/1m): 83dB

Enclosure type: Sealed

Dimensions (H x W x D): 11-25/32" x 4-11/32" x 3-15/32"

(299mm x 110mm x 88mm), including stands

Weight: 3.4 lb (1.55kg)

CEN-TS60 Center Speaker

Midrange transducers: Dual 3" (75mm) honeycomb at-diaphragm

drivers, video-shielded

High-frequency transducer: 1" (25mm) CMMD Lite dome, video-shielded

Suggested amplier power range: 20 – 150 watts

Nominal impedance: 8 ohms

Sensitivity (2.83V/1m): 83dB

Enclosure type: Sealed

Dimensions (H x W x D): 4-11/32" x 10-11/32" x 3-15/32"

(110mm x 272mm x 88mm), including stands

Weight: 3.3 lb (1.5kg)

HKTS220SUB Wireless Subwoofer

Low-frequency transducer: 8" (200mm) down-ring cone

Amplier power: 200 watts (continuous), 400 watts (peak)

Frequency response: 45Hz – 200Hz (–6dB)

Controls: Volume, phase, bass boost

Connections: LFE (RCA-type); left and right line-level (RCA-

type)

Enclosure type: Sealed

External trigger input voltage: 3 – 30 volts, AC or DC

Subwoofer power requirement: 120V, 60Hz (USA); 220V – 240V, 50/60Hz (EU)

Subwoofer power consumption: <0.5W (standby); 243W (maximum, 120V);

261W (maximum, 230V)

Subwoofer dimensions

(H x W x D):

13-29/32" x 10-1/2" x 10-1/2"

(353mm x 267mm x 267mm)

Subwoofer weight: 19.8 lb (9kg)

Transmitter power requirement: 100 – 240V AC, 50/60Hz

Transmitter power consumption: <0.5W

Transmitter unit dimensions

(H x W x D):

1-3/8" x 5" x 3-1/2"

(35mm x 127mm x 89mm)

Transmitter unit weight: 0.26 lb (117g)

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Harman Kardon HKTS 65BQ in the language / languages: English as an attachment in your email.

The manual is 3,79 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Harman Kardon HKTS 65BQ Manual

Product: