502808

Harman Kardon HK 3385 Manual

17
Zoom out
Zoom in
Previous page
1/28
Next page
17
You are now ready to connect your various components to your receiver.
Before beginning, make sure that all components, including the HK 3385,
are turned completely off and their power cords are unplugged. Don’t
plug any of the power cords back in until you have finished
making all of your connections.
Remember that your receiver generates heat while it is on. Select a
location that leaves several inches of space on all sides of the receiver. It
is preferable to avoid completely enclosing the receiver inside a cabinet.
It is also preferable to stack components on separate shelves rather
than directly on top of the receiver. Some surface finishes are delicate.
Try to select a location with a sturdy surface finish.
Step One – Connect the Speakers
If you have not yet done so, place your speakers in the listening room
as described in the Speaker Placement section.
Connect the front left and right loudspeakers to the Speaker 1 speaker
terminals on the HK 3385. Remember to maintain the proper polarity by
always connecting the positive and negative terminals on each speaker
to the positive and negative terminals on the receiver. If you wish to
place a second pair of speakers in another room, or in the same room
for additional sound power, connect those speakers to the Speaker 2
Outputs, again remembering to maintain polarity. You may use the
Speaker 1/2 Selector on the front panel or remote to activate either
or both pairs of speakers simultaneously. See Figure 9.
Figure 9 – Speaker Connections
Step Two – Connect the Subwoofer
Connect the Subwoofer Outputs on the HK 3385 to the line-level inputs
on your subwoofer. The same full-range signal is output through both jacks.
Thus, you have the option of connecting each jack to the line-level input
on a separate subwoofer. If you have only one subwoofer with a single
line-level input, connect it to the right Subwoofer Output on the HK 3385.
See Figure 10. Consult the manufacturer’s guide for the subwoofer for
additional information.
Figure 10 – Subwoofer Connection
Step Three – Connect the Antennas
Connect the FM and AM antennas to their terminals. See Figure 11.
Figure 11 – Antenna Connections
Step Four – Connect the Source Components
Use the worksheets in the Appendix to note which connections you will
use for each of your source devices.
For each source, select a source input (Video 1, Video 2, Video 3, etc.).
In Table 2 we recommend connecting certain types of sources to certain
source inputs to make it easier to use the remote control.
The remote is preprogrammed to operate certain Harman Kardon
components as shown in Table 2. However, you may connect any
component with analog audio and/or composite video outputs to
any source input on the HK 3385, with the exception of the Phono
Inputs, and you may use the original remote control supplied with
the component. It is not possible to reprogram the HK 3385 remote,
or to change the device type associated with any source input.
FM
AM
HK 3385
HK 3385
SUB
Right (Spkr 1) Right (Spkr 2) Left (Spkr 1)Left (Spkr 2)
HK 3385
17
INSTALLATION
HK 3385 OM 4/13/07 12:02 PM Page 17
… 17 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Harman Kardon HK 3385 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Harman Kardon HK 3385 in the language / languages: English as an attachment in your email.

The manual is 3,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info