502641
8
Zoom out
Zoom in
Previous page
1/24
Next page
8
FED
12 0 6 C 7 8 9 A
3
B4 G 5 H
AVR 142
FRONT PANEL CONTROLS
AVR Audio/Video Receiver
Front Panel Controls
Main Power Switch: Press this button to apply
power to the AVR. When the switch is pressed in, the
unit is placed in a Standby mode, as indicated by the
orange LED
. This button MUST be pressed in to
operate the unit. To turn the unit off completely and
prevent the use of the remote control, this switch
should be pressed until it pops out from the front
panel so that the word “OFF” may be read at the top of
the switch.
NOTE
: This switch is normally left in the ON” position.
System Power Control: When the Main Power
Switch
is “ON, press this button to turn on the
AVR; press it again to turn the unit off (to Standby).
Note that the Power Indicator
will turn blue
when the unit is on.
Power Indicator: This LED will be illuminated in
orange when the unit is in the Standby mode to signal
that the unit is ready to be turned on. When the unit is
in operation, the indicator will turn blue.
Headphone Jack: This jack may be used to listen
to the AVR’s output through a pair of headphones.
Be certain that the headphones have a standard 6.3
mm stereo phone plug. Note that the speakers will
automatically be turned off when the headphones are
connected.
Digital Optical 3 Input: Connect the optical
digital audio output of an audio or video product to
this jack.
Aux input stereo minijack: Connect this
minijack to any audio source, typically MP3 players or
portable CD players. An analog headphone output jack
or line level out jack may be used.
Surround Mode Group Selector: Press this
button to select the top-level group of surround
modes. Each press of the button will select a major
mode grouping in the following order:
Dolby Modes
C
DTS Digital Modes
C
DSP Modes
C
Stereo Modes
C
Logic 7 Modes
Once the button is pressed so that the name of the
desired surround mode group appears in the Lower
Display Line
, press the Surround Mode
Selector
to cycle through the individual modes
available. For example, press this button to select
Dolby modes, and then press the Surround Mode
Selector
to choose from the various mode
options.
Tuning Selector: Press the left side of the
button to tune lower frequency stations and the right
side of the button to tune higher frequency stations.
When a station with a strong signal is reached,
e
or
e
will appear
in the Main Information Display
(see page 20
for more information on tuning stations).
Tuner Band Selector: Pressing this button will
automatically switch the AVR to the Tuner mode.
Pressing it again will switch between the AM and FM
frequency bands, holding it pressed for some seconds
will switch between stereo and mono receiving and
between automatic and manual tuning mode (See
page 20 for more information on the tuner).
Preset Stations Selector: Press this button to
scroll up or down through the list of stations that have
been entered into the preset memory. (See page 20 for
more information on tuner programming.)
Input Source Selector: Press this button to
change the input by scrolling through the list of input
sources.
RDS Select Button: Press this button to display
the various messages that are part of the RDS data
system of the AVR’s tuner. (See page 20 for more
information on RDS).
Surround Mode Selector: Press this button
to select from among the available surround mode
options for the mode group selected. The specific
modes will vary based on the number of speakers
available, the mode group and if the input source is
digital or analog. For example, press the Surround
Mode Group Selector
to select a mode grouping
such as Dolby or Logic 7, and then press this button to
see the mode choices available. For more information
on mode selection, see page 13.
Volume Control: Turn this knob clockwise to
increase the volume, counterclockwise to decrease the
volume. If the AVR is muted, adjusting volume control
will automatically release the unit from the silenced
condition.
Remote Sensor Window: The sensor behind
this window receives infrared signals from the remote
control. Aim the remote at this area and do not
block or cover it unless an external remote sensor is
installed.
Main Information Display: This display delivers
messages and status indications to help you operate
the receiver.
Digital Coax 3 Input: This jack is normally used
for connection to the output of portable digital audio
devices, video game consoles or other products that
have a coax digital jack.
Video 3 Input Jacks: These audio/video jacks
may be used for temporary connection to video games
or portable audio/video products such as camcorders
and portable audio players.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Harman Kardon AVR142 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Harman Kardon AVR142 in the language / languages: English as an attachment in your email.

The manual is 0,49 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Harman Kardon AVR142

Harman Kardon AVR142 User Manual - German - 24 pages

Harman Kardon AVR142 User Manual - Dutch - 24 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info