Manual Harman Kardon AVR 4000 (page 16 of 58) (English)

8518

Zoom out

Zoom in

1/58

16 INSTALLATION AND CONNECTIONS

Installation and Connections

SCART A/V Connections

For the connections described above your video

device needs RCA (cinch) connectors or/and S-

Video connectors for all Audio and Video signals:

Any normal video device (Not SVHS or High 8)

for only playback needs 3 RCA jacks, VCRs for

record and playback even 6 RCA jacks. Any S-

Video device (SVHS, High 8) needs 2 RCA

(Audio) and 1 S-Video jack (Video), if it´s a

playback unit, or 4 RCA (Audio In/Out) and

2 S-Video (Video In/Out) jacks, if it´s a recording

VCR.

Many european video devices are equipped with

RCA (Cinch) or S-Video jacks only partially, not

for all audio and video in/outputs needed as

described above, but with a so called Scart or

Euro-AV connector (almost rectangular jack with

21 pins, see drawings on this page).

In that case the following Scart to Cinch

adapters or cables are needed:

• Units for playback, such as satellite receivers,

camcorders, DVD or LD players, need an

adapter from Scart to 3 RCA plugs, see fig. 1

(normal video devices) or from Scart to 2

RCA+1 S-Video plugs, see fig. 4 (S-Video

devices).

• HiFi VCRs need an adapter from Scart to 6

RCA plugs, see fig. 2 (normal video), or from

Scart to 4 Audio+2S-Video jacks, see fig. 5

(S-Video VCR). Read carefully the instruction

attached to the adapter to find which of the

six plugs is used for the record signal to the

VCR (connect with the AVR´s Out jacks) and

for the playback signal from the VCR (connect

with the AVR´s In jacks). Do not misconnect

Audio and Video signals. Don´t hesitate to

consult your dealer, if you are uncertain.

• If you use only normal video devices the TV

monitor needs an adapter from 3 RCA plugs

to Scart (fig. 3) only. If also S-Video devices are

used an adapter from 2 RCA+1S-Video plugs

to Scart is needed additionally (fig. 6),

connected to the SCART input on your TV that

is provided for S-Video.

Note that only the video plugs (the "yellow"

cinch plug in fig. 3 and the S-Video plug in fig.

6) must be connected to the TV Monitor

Output

, and the volume on the TV must be

reduced to minimum.

Black

Yellow

Red

Figure 1:

SCART/Cinch-Adapter for

playback;

signal flow:

SCART → Cinch

Black

Red

Blue

Yellow

Green

White

Figure 2:

SCART/Cinch-Adapter for

record and playback;

signal flow:

SCART ↔ Cinch

Black

Yellow

Red

Figure 3:

Cinch/SCART-Adapter for

playback;

signal flow:

Cinch → SCART

Rot

Schwarz

S-Video In

Figure 4:

SCART/S-Video Adapter

for playback;

signal flow:

SCART → Cinch

Schwarz

Rot

Blau

Gelb

S-Video In

S-Video Out

Figure 5:

SCART/S-Video Adapter

for record and playback;

signal flow:

SCART ↔ Cinch

Rot

Schwarz

S-Video Out

Figure 6:

SCART/S-Video Adapter

for playback;

signal flow:

Cinch → SCART

Black

Yellow

Red

Black

Red

Blue

Yellow

Green

White

Black

Yellow

Red

Black

S-Video In

Red

Black

S-Video Out

Black

Red

Blue

Yellow

S-Video In

S-Video Out

Also other colours possible, e.g. brown and grey.

Important Note for Adapter Cables:

If the cinch connectors of the adapter you’ll use

are labeled, connect the Audio and Video ”In”

plugs with the corresponding Audio and Video

”In” jacks on the AVR 4000 (and with a VCR

connect the ”Out” plugs to the ”Out” jacks on

the AVR). Note that with some adapter types it

may be just turned around: If no signal is audi-

ble/ visible when the VCR is playing connect the

“Out” plugs to the ”In” jacks on the AVR and

turned around. If the adapter plugs are not

labeled in that way, pay attention to the signal

flow directions as shown in the diagrams above

and in the instruction attached to the adapter. If

uncertain, don’t hesitate to consult your dealer.

Important Notes for S-Video connections:

1. Only the S-Video In/Out of S-Video devices

must be connected to the AVR, NOT both, nor-

mal video and S-Video In/Outputs (except the TV,

see item 2).

2. Like most common AV units the AVR 4000

does not convert the Video signal to S-Video or

vice versa. Thus both connections must be made

from the AVR 4000 to the TV if both, Video and

S-Video sources, are used, and the appropriate

input on the TV must be selected.

i need circuit diagram for avr 4000 to repair the safety mood Submitted on 1-1-2023 at 14:31
Reply Report abuse

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Harman Kardon AVR 4000 in the language / languages: English as an attachment in your email.

The manual is 1,09 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Harman Kardon AVR 4000

Harman Kardon AVR 4000 User Manual - Dutch - 58 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Harman Kardon AVR 4000 Manual

Product: