Manual Harman Kardon AVR 335 (page 5 of 56) (English)

642268

Zoom out

Zoom in

1/56

FRONT-PANEL CONTROLS

1 Main P

wer Switch:

Press this button to apply

power to the AVR 335. When the switch is pressed

in, the unit is in a Standby mode, as indicated by the

amber

Power Indicator 2 above the Standby/On

Switch

3. This button MUST be pressed in to

operate the unit.

To turn the unit off and prevent the

use of the remote control,

this switch should be

pressed until it pops out from the front panel and the

word “OFF” is seen at the top of the switch.

NOTE: This switch is normally left in the “ON” position.

2 P

ower Indicator:

This LED lights amber when the

unit is in the Standby mode to signal that the

VR is

ready to be turned on. When the unit is in operation,

the indicator is blue.

3 Standby/On Switch: When the Main Power

Switch

“ON

”

press this button to turn on the

AVR 335; press it again to turn the unit off. The

Power

Indicator

turns blue when the unit is on.

4 Headphone Jack: This jack may be used to listen

to the AVR 335’s output through a pair of headphones.

The speakers will automatically be turned off when the

headphone jack is in use. When configuring your sys-

tem using EzSet+, the calibration microphone should

be plugged into this jack using the supplied adaptor

that converts the small mini-plug at the end of the

microphone’s cord to a 1/4" plug.

5 Tone Mode: Pressing this button enables or dis-

ables the Bass and Treble tone controls. When the but-

ton is pressed so that

TONE

appears in the

Lower Display Line ¯, the Bass  and Treble

Ú controls may be used to adjust the output signals.

When the button is pressed once or twice so that the

words

TONE

OUT

appear in the Lo

wer Display

Line

¯, the output signal will be “flat,” no matter how

the actual

Bass and Treble Controls Ú are

adjusted.

6 Speaker Select Button: Press this button to

begin the process of configuring the unit to match the

type of speakers used in your listening room. (See

pages 22–24 for more information on speaker setup

and configuration.)

7 Surround Mode Group Selector: Press this but-

ton to select the top-level group of surround modes

Each press of the button will select the current or last

used mode in each of the surround mode groups

(e.g., Dolby, DTS, DTS Neo:6, Logic 7, DSP, Stereo).

When the button is pressed so that the name of the

desired surround mode group appears in the on-

screen display and in the

Lower Display Line ¯,

press the

Surround Mode Selector 8 to cycle

through the individual modes available. For example,

press this button to select Dolby modes

and then

press the

Surround Mode Selector 8 to choose

from the various mode options.

1 Main Power Switch

2 Power Indicator

3 Standby/On Switch

4 Headphone Jack

5 Tone Mode

6 Speaker Selector

7 Surround Mode Group Selector

8 Surround Mode Selector

9 Tuning Selector

)

‹/›

Buttons

! Tuner Band Selector

@ Set Button

# Digital Input Selector

$ Preset Station Selector

% Delay Adjust Selector

^ Input Source Selector

& Tuner Mode Selector

* Optical 4 Digital Input

( Coaxial 4 Digital Input

Ó Video 4 Video Input Jacks

Ô Video 4 Audio Input Jacks

 Bass Control

Ò Balance Control

Ú Treble Control

Û Channel Adjust Selector

Ù Volume Control

ı Input Indicators

ˆ Speaker/Channel Input Indicators

˜ Upper Display Line

¯ Lower Display Line

˘ Surround Mode Indicators

¸ Remote Sensor Window

FRONT-PANEL CONTROLS

FRONT-PANEL CONTROLS 55

NOTE: To make it easier to follow the instructions that refer to this illustration, a larger copy may be downloaded from the Product Support section for this product at

www.harmankardon.com.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Harman Kardon AVR 335 in the language / languages: English as an attachment in your email.

The manual is 1,5 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Harman Kardon AVR 335

Harman Kardon AVR 335 User Manual - Dutch - 50 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Harman Kardon AVR 335 Manual

Product: