Manual Harman Kardon AVR 335 (page 4 of 56) (English)

642268

Zoom out

Zoom in

1/56

SAFETY INFORMATION

Important Safety Information

Verify Line Voltage Before Use

Your AVR 335 has been designed for use with

120-volt AC current. Connection to a line voltage

other than that for which it is intended can create a

safety and fire hazard and may damage the unit.

If you have any questions about the voltage requirements

for your specific model, or about the line voltage in your

area, contact your selling dealer before plugging the unit

into a wall outlet.

Do Not Use Extension Cords

To avoid safety hazards, use only the power cord

attached to your unit. We do not recommend that

extension cords be used with this product. As with all

electrical devices, do not run power cords under rugs

or carpets or place heavy objects on them. Damaged

power cords should be replaced immediately by an

authorized service center with a cord meeting factory

specifications.

Handle the AC Power Cord Gently

When disconnecting the power cord from an AC out-

let, always pull the plug; never pull the cord. If you do

not intend to use the unit for any considerable length

of time, disconnect the plug from the AC outlet.

Do Not Open the Cabinet

There are no user-serviceable components inside this

product. Opening the cabinet may present a shock

hazard, and any modification to the product will void

your guarantee. If water or any metal object such as a

paper clip, wire or a staple accidentally falls inside the

unit, disconnect it from the AC power source immedi-

ately, and consult an authorized service center.

CATV or Antenna Grounding

If an outside antenna or cable system is connected

to this product, be certain that it is grounded so as to

provide some protection against voltage surges and

static charges

Section 810 of the National Electrical

Code, ANSI/NFPA No. 70-1984, provides information

with

respect to proper grounding of the mast and

supporting structure

grounding of the lead-in wire to an

antenna

discharge unit, size of grounding conductors,

location of antenna discharge unit, connection to

grounding electrodes and requirements of the

grounding electrode.

NOTE

TO CA

TV SYSTEM INST

ALLER:

This reminder

is provided to call the CATV (Cable TV) system

installer’s attention to article 820-40 of the NEC that

provides guidelines for proper grounding and,

in par-

ticular

specifies that the cable ground shall be con

nected to the grounding system of the building, as

close to the point of cable entry as possible.

Installa

tion Location

n T

o ensure proper operation and to avoid the poten-

tial for safety hazards, place the unit on a firm and

level surface. When placing the unit on a shelf, be

certain that the shelf and any mounting hardware

can support the weight of the product.

n Make certain that proper space is provided both

above and below the unit for ventilation.

If this

product will be installed in a cabinet or other

enclosed area, make certain that there is sufficient

air movement within the cabinet. Under some cir-

cumstances a fan may be required.

n Do not place the unit directly on a carpeted

surface.

n Avoid installation in extremely hot or cold locations,

or in an area that is exposed to direct sunlight or

heating equipment.

n Avoid moist or humid locations.

n Do not obstruct the ventilation slots on the top of

the unit, or place objects directly over them.

n Due to the weight of the AVR 335 and the heat

generated by the amplifiers, there is the remote

possibility that the rubber padding on the bottom

of the unit’s feet may leave marks on certain

wood or veneer materials. Use caution when

placing the unit on soft woods or other materials

that may be damaged by heat or heavy objects.

Cleaning

When the unit gets dirty, wipe it with a clean, soft, dry

cloth. If necessary, and only after unplugging the power

cord, wipe it with a soft cloth dampened with mild soapy

water, then a fresh cloth with clean water. Wipe dry

immediately with a dry cloth. NEVER use benzene,

aerosol cleaners, thinner, alcohol or any other volatile

cleaning agent.

Do not use abrasive cleaners, as they

may damage the finish of metal parts. Avoid spraying

insecticide near the unit.

Moving the Unit

Before moving the unit,

be certain to disconnect any

interconnection cords with other components, and

make certain that you disconnect the unit from the

AC outlet.

Important Information for the User

This equipment has been tested and found to comply

with the limits for a Class-B digital device, pursuant to

Part 15 of the FCC Rules. The limits are designed to

provide reasonable protection against har

mful interfer

ence in a residential installation. This equipment gener-

ates,

uses and can radiate radio-frequency energy

and,

if not installed and used in accordance with the

instructions, may cause harmful interference to radio

communication.

However

, there is no guarantee that

harmful interference will not occur in a particular instal-

lation.

If this equipment does cause harmful interfer-

ence to radio or television reception,

which can be

determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by

one or more of the following measures:

n Reorient or relocate the receiving antenna.

n Increase the separation between the equipment

and receiver.

n Connect the equipment into an outlet on a circuit

different from that to which the receiver is connected.

n Consult the dealer or an experienced radio/TV

technician for help.

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1) this device may not cause harmful interference,

and (2) this device must accept interference

received, including interference that may cause

undesired operation.

NOTE: Changes or modifications may cause this unit

to fail to comply with Part 15 of the FCC Rules and may

void the user’s authority to operate the equipment.

Unpacking

The carton and shipping materials used to protect

your new receiver during shipment were specially

designed to cushion it from shock and vibration. We

suggest that you save the carton and packing materials

for use in shipping if you move, or should the unit ever

need repair.

To minimize the size of the carton in storage, you may

wish to flatten it. This is done by carefully slitting the

tape seams on the bottom and collapsing the carton.

Other cardboard inserts may be stored in the same

manner. Packing materials that cannot be collapsed

should be saved along with the carton in a plastic bag

If you do not wish to save the packaging materials,

please note that the carton and other sections of the

shipping protection are recyclable

Please respect the

environment and discard those materials at a local

recycling center.

it is important that you remove the protective plastic

film from the front-panel lens. Leaving the film in place

will affect the perfor

mance of your remote control.

4 SAFETY INFORMATION4 SAFETY INFORMATION

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Harman Kardon AVR 335 in the language / languages: English as an attachment in your email.

The manual is 1,5 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Harman Kardon AVR 335

Harman Kardon AVR 335 User Manual - Dutch - 50 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Harman Kardon AVR 335 Manual

Product: