711834
35
Zoom out
Zoom in
Previous page
1/48
Next page
Materials required for assemblyPage 12
The exhaust hood must be placed
over the centre of the cooking zone
in order for it to operate at Exhaust hood full
capacity later.
Please note!
To avoid damage to the appliance from
dust caused by the drilling, we recommend
drilling the holes for the wall mount for the
flue before installing the exhaust hood.
If possible, move the cooker aside so that
you have enough space to install the ex-
haust hood. Use a stable stepladder and
always have a second person assist you.
min.
65
cm
1. To position the appliance exactly over the
centre of the cooker, first draw a refer-
ence line on the wall (a vertical line drawn
using a level or plumb-bob from the cen-
tre of the cooker to the ceiling).
2. Hold the exhaust hood (1) up to the wall
in such a way that the distance from the
cooker (for gas cookers, at least 65 cm)
is correct and the middle of the exhaust
hood is flush to the vertical guideline.
Check the alignment using a level.
50 cm
50 cm
40 cm
c
5
cm
3. Use a pencil to mark the four drilling holes
using the hangers.
The two outer drilling holes for the hanger
must have a clearance of 50 cm. Both in-
ner drilling holes for the fuse must have a
clearance of 40 cm and must be offset from
the outer drilling holes by 5 cm each.
4. Remove the exhaust hood again.
50 cm
50 cm
50 cm
40 cm
40 cm
5
cm
5. Drill a hole with the same diameter as the
wall plug into the wall to a sufficient depth
at each of the marked points.
2x
6. Insert all four screw wall plugs into the
drilled holes.
7. Screw in two fixing screws in the outer
wall plugs. Around 1 cm of both fixing
screws must be left protruding.
(7)
35


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hanseatic SY-103D1-E3-C25-900 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hanseatic SY-103D1-E3-C25-900 in the language / languages: English, German as an attachment in your email.

The manual is 2,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info