607479
8
Zoom out
Zoom in
Previous page
1/37
Next page
16 17
AC Adaptor:
The AC Adaptors are low voltage power source that allow you to use
your household electricity to run the Baby Monitor. Connect the AC
Adaptors to the AC Adaptor Jack in the Parents and Baby Unit. Both
plug into any standard volt electrical outlet in your home. It is
recommended to turn off the units before plug in or unplug the
adaptors.
CAUTION: These adaptors were made with a specific design for this
product. They cannot be used with any other appliance. Never use a
different type of adaptor with Baby Monitor.
CAUTION
This product cannot replace responsible adult supervision.
This Baby Monitor is intended as an aid. Do not use it as a medical monitor or
a substitute for responsible and proper adult supervision.
Make sure the Receiver and adaptor cable are always out of child‘s reach. Do
not place the Receiver inside the baby‘s crib or playpen!
The antenna on the Units are xed, do not try to extend them. Never attempt to
modify the product.
Avoid using the product near water and expose to rain or moisture.
Receiver & Transmitter Battery Installation
1. Locate the battery compartment door on the
back of the Units.
2. Open the battery compartment door.
3. Insert 3 * AAA batteries into the Receiver and
the Transmitter according to the +/- signs shown
in the battery compartment, respectively.
4. Replace battery compartment doors.
Battery Tips:
If the product is not in use for a long time, disconnect both units from the
household electrical outlet. And remove the batteries or the exhausted
batteries from the units, otherwise battery leakage and corrosion can damage
them.
Non-rechargeable battery is not to be recharged
Rechargeable batteries are only to be charged under adult supervision.
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace
only with the batteries of the same and equivalent type.
Transmitter & Receiver Battery Charging
If the battery level becomes low, in both LCD displays the empty battery icon.The
battery icon and the out of range alarm icon ash, in order to warn you about the
low battery level. The receiver also emits a warning tone continually.
Charging the batteries
Please charge the rechargeable batteries rst time usage.
The rechargeable batteries to the transmitter and receiver must not be taken out
of the units for charging. The battery icon loops and ashes while charging. It
stops ashing when the batteries are fully charged.
Charging the transmitter
1. Connect the power supply unit to the thin plug on the 6V-socket of the
transmitter.
2. Once the power supply unit is connected to the transmitter, charging
automatically begins.
3. The charging time for completely charging empty battery takes about 9 hours
when the transmitter is turned off.
Charging the receiver
1. Connect the power supply unit to the thick plug on the charger stand socket.
2. Once the power supply unit is connected to the charger stand and the receiver
is on the charger stand, charging automatically begins.
3. The charging time for completely empty batteries and turned off unit is
about 9 hours.
Remarks:
1. Use only the DC adaptors or desktop charger stand which are included in the
package. Plug into any nearby standard household electrical outlet.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hama BC300 - 92660 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hama BC300 - 92660 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 0,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info