683782
13
Zoom out
Zoom in
Previous page
1/38
Next page
A Key switch
turns the electrical system ON/OFF
and protects the machine against
unauthorized use; moreover it holds
the hourmeter display. With the
switch in OFF position, all control
functions are reset to the initial
state (reset).
B Horn button
actuates the electric horn.
C Pilot lamp (yellow)
for brush pressure
alights if the brush pressure pedal
(II/3) is depressed
45
D Pilot lamp (red)
for max. filling level
alights if the maximum filling level in
the soiled water tank is attained.
E Pilot lamp (red)
for parking brake
alights if the parking brake pedal
(I/4) is depressed. If the travel drive
assembly is switched on a buzzer
sound in addition.
F Pilot lamp (red)
for fault display
alights in case of one of the
following faults occurring:
thermostat switch of the brush or
drive motor has closed
one of the fuses is defective or
one of the electronic circuit-
breakers tripped
other faults
Electronic circuit breakers
In addition to the fuses, the Hako-
matic B 910 is equipped with elec-
tronic circuit-breakers for the main dri-
ves. In case of overload one of the
electronic circuit breakers responds,
the fault lamp (F) alights and an error
code appears in the hourmeter
display.
The reset can only be effectuated by
turning the key switch to ”OFF”.
If the electronic circuit-breaker trips
again after re-starting, the cause has
to be detected.
G Hourmeter/service display
displays the operation hours. The
meter only counts if the consumers
e.g. drive or brush motor, suction
turbine or pre-sweeper are ON. A
red dot at the right bottom of the
display flashes simultaneously.
A Key switch
turns the electrical system ON/OFF
and protects the machine against
unauthorized use; moreover it holds
the hourmeter display. With the
switch in OFF position, all control
functions are reset to the initial
state (reset).
B Horn button
actuates the electric horn.
C Pilot lamp (yellow)
for brush pressure
alights if the brush pressure pedal
(II/3) is depressed
45
D Pilot lamp (red)
for max. filling level
alights if the maximum filling level in
the soiled water tank is attained.
E Pilot lamp (red)
for parking brake
alights if the parking brake pedal
(I/4) is depressed. If the travel drive
assembly is switched on a buzzer
sound in addition.
F Pilot lamp (red)
for fault display
alights in case of one of the
following faults occurring:
thermostat switch of the brush or
drive motor has closed
one of the fuses is defective or
one of the electronic circuit-
breakers tripped
other faults
Electronic circuit breakers
In addition to the fuses, the Hako-
matic B 910 is equipped with elec-
tronic circuit-breakers for the main dri-
ves. In case of overload one of the
electronic circuit breakers responds,
the fault lamp (F) alights and an error
code appears in the hourmeter
display.
The reset can only be effectuated by
turning the key switch to ”OFF”.
If the electronic circuit-breaker trips
again after re-starting, the cause has
to be detected.
G Hourmeter/service display
displays the operation hours. The
meter only counts if the consumers
e.g. drive or brush motor, suction
turbine or pre-sweeper are ON. A
red dot at the right bottom of the
display flashes simultaneously.
A Key switch
turns the electrical system ON/OFF
and protects the machine against
unauthorized use; moreover it holds
the hourmeter display. With the
switch in OFF position, all control
functions are reset to the initial
state (reset).
B Horn button
actuates the electric horn.
C Pilot lamp (yellow)
for brush pressure
alights if the brush pressure pedal
(II/3) is depressed
45
D Pilot lamp (red)
for max. filling level
alights if the maximum filling level in
the soiled water tank is attained.
E Pilot lamp (red)
for parking brake
alights if the parking brake pedal
(I/4) is depressed. If the travel drive
assembly is switched on a buzzer
sound in addition.
F Pilot lamp (red)
for fault display
alights in case of one of the
following faults occurring:
thermostat switch of the brush or
drive motor has closed
one of the fuses is defective or
one of the electronic circuit-
breakers tripped
other faults
Electronic circuit breakers
In addition to the fuses, the Hako-
matic B 910 is equipped with elec-
tronic circuit-breakers for the main dri-
ves. In case of overload one of the
electronic circuit breakers responds,
the fault lamp (F) alights and an error
code appears in the hourmeter
display.
The reset can only be effectuated by
turning the key switch to ”OFF”.
If the electronic circuit-breaker trips
again after re-starting, the cause has
to be detected.
G Hourmeter/service display
displays the operation hours. The
meter only counts if the consumers
e.g. drive or brush motor, suction
turbine or pre-sweeper are ON. A
red dot at the right bottom of the
display flashes simultaneously.
A Key switch
turns the electrical system ON/OFF
and protects the machine against
unauthorized use; moreover it holds
the hourmeter display. With the
switch in OFF position, all control
functions are reset to the initial
state (reset).
B Horn button
actuates the electric horn.
C Pilot lamp (yellow)
for brush pressure
alights if the brush pressure pedal
(II/3) is depressed
45
D Pilot lamp (red)
for max. filling level
alights if the maximum filling level in
the soiled water tank is attained.
E Pilot lamp (red)
for parking brake
alights if the parking brake pedal
(I/4) is depressed. If the travel drive
assembly is switched on a buzzer
sound in addition.
F Pilot lamp (red)
for fault display
alights in case of one of the
following faults occurring:
thermostat switch of the brush or
drive motor has closed
one of the fuses is defective or
one of the electronic circuit-
breakers tripped
other faults
Electronic circuit breakers
In addition to the fuses, the Hako-
matic B 910 is equipped with elec-
tronic circuit-breakers for the main dri-
ves. In case of overload one of the
electronic circuit breakers responds,
the fault lamp (F) alights and an error
code appears in the hourmeter
display.
The reset can only be effectuated by
turning the key switch to ”OFF”.
If the electronic circuit-breaker trips
again after re-starting, the cause has
to be detected.
G Hourmeter/service display
displays the operation hours. The
meter only counts if the consumers
e.g. drive or brush motor, suction
turbine or pre-sweeper are ON. A
red dot at the right bottom of the
display flashes simultaneously.
Scrub-
master B140 R is equipped with elec-
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hako Scrubmaster B140R at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hako Scrubmaster B140R in the language / languages: English as an attachment in your email.

The manual is 1,09 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info