811864
51
Zoom out
Zoom in
Previous page
1/59
Next page
GB
24
11.7. Standby
The stove is in waiting condition. Before it can be switched over from the operating setting "standby" to the
operating setting "Start zones 1 20", two conditions for the start are to be fulfilled:
The "Actual room temperature" must drop under the "Setpoint temperature" by 1 °C at least
The temperature of the combustion products measured by temperature sensor must be lower than 70 °C
11.8. Shut down
If a fault occurs, then a shut down is initiated. The components are switched on or off as follows:
Induced draught fan ON and Screw conveyor OFF and Ignition OFF
11.9. Cooling
The end of the shut down process depends on time and temperature.
11.10. Error display - Fault
The stove can no longer be automatically started up. The operator
can see the fault on the display. Once the fault has been properly
corrected and the error message on the operator console has been
cleared, the stove can be started up again.
Procedure:
The error is cleared by pressing the "OK" button.
Welcome page is displayed.
Combustion chamber door
open
F0009
OK
Note
Otherwise please read the information under Faults, causes, correction.
11.11. OFF
12. Overheating protection
A safety temperature limiter (STL) automatically switches the stove off if it overheats. The error F001 is shown
on the console display under operating status. In this case, the appliance must be inspected by a qualified
technician!
13. Power cut
The control unit has a backup battery so that data is retained during a power cut.
A distinction is made between a short power cut and a long power cut.
Short power cut lasts for less than about 30 seconds:
51


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Haas-Sohn HSP 4.0-F3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Haas-Sohn HSP 4.0-F3 in the language / languages: English as an attachment in your email.

The manual is 5.55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Haas-Sohn HSP 4.0-F3

Haas-Sohn HSP 4.0-F3 User Manual - German - 36 pages

Haas-Sohn HSP 4.0-F3 User Manual - French - 61 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info