Manual Haas-Sohn HSP 4.0-F3 (page 50 of 59) (English)

811864

Zoom out

Zoom in

1/59

11. Oper. modes

11.1. Burner test before start zone

The start zone begins if:

• the current room temperature falls below the set target temperature by 1 °C

• the stove is cooled down to a temperature below 70 °C

A burner test is performed before each start zone. After a successful burner test the start zone is initiated.

11.2. Start zone 1-30 (start zone)

The whole "start zone" can go through up to 30 zones. It finishes after reaching a precisely defined

temperature at the "flame temperature sensor" and the control system puts the stove into "Heating mode".

The duration of the "start zone" can therefore vary.

If, during the start zone, no flame generation can be achieved or the required temperature at the "flame

temperature sensor" cannot be reached, a shut down process is initiated.

11.3. Heating mode

After the positive conclusion of the "start zone", the stove automatically switches to "Heating mode".

Manual control: The heat output of the stove is regulated in 5 preset levels. The higher the level (1-5), the

higher the heat output.

Automatic control: The heat output is controlled according to the difference between the set and Actual room

temperature.

11.4. Burner test (when heating)

During the "Heating mode" operating state, the burner test is started in cycles depending on the selected

heat output level. The burner test takes approx. 3 min.

11.5. Cooling down

If the set Setpoint temperature is reached or the "ON/OFF" button is pressed, then the operating status

switches to "cooling down". The cooling down phase is restricted by timing control (duration about 15

minutes). After the end of the "Cooling down" operating status, the appliance switches to "standby" operating

status or "OFF".

11.6. ECO-Mode

If the ECO-Mode mode is activated, the stove will not turn off when the "Setpoint temperature" is reached. The

stove continues to burn with a "smaller flame". If the "Setpoint temperature" is exceeded by more than 3 °C,

then:

• the stove enters the "Cooling down" operating mode

• if the "Actual room temperature" exceeds 30 °C in the ECO-Mode operating mode, the stove enters the

"Cooling down" operating mode.

The ECO-Mode remains active in both cases.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Haas-Sohn HSP 4.0-F3 in the language / languages: English as an attachment in your email.

The manual is 5.55 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Haas-Sohn HSP 4.0-F3

Haas-Sohn HSP 4.0-F3 User Manual - German - 36 pages

Haas-Sohn HSP 4.0-F3 User Manual - French - 61 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Haas-Sohn HSP 4.0-F3 Manual

Product: