625744
8
Zoom out
Zoom in
Previous page
1/28
Next page
8
START 200 / 300
EN
PROTECTION
This device has been designed with maximum protection:
• The charging clamps are fully insulated.
• A fuse provides proctection against reverse polarity and short circuits :
Start 200 Start 300
Primary fuse Cylindrical type 6.35x31.75 - Fast
acting - 5A (little fuse ref : 53346)
Cylindrical type 6.35c31.75 10A -
Little Fuse. (Ref. 53356)
Secondary fuse 300mm - 50A (Little fuse serie : BF1
- 32 (Little Fuse ref : 51342)
Little Fuse BF1 type - 80A (Ref.
53353)
• The thermal protection is covered by a thermostat (cooling time is around 15mins). The green light turns itself off in
the event of overheating for the Start 200, or the orange light turns itself on for the Start 300.
SULPHATED OR DAMAGED BATTERIES
START does not detect sulphated or damaged batteries.
Your battery is deeply damaged if in charge, the ammeter needle deects rapidly to very high intensities. Your battery
is permanently out of use.
• In the case of a sulphated battery : turn the device on the highest speed "BOOST" and regularly monitor if the
ammeter shows a charging current. As soon as the charging current increases, put the switch onto the suitable charging
mode for the battery. If there is no improvement after 5 hours, the battery is permanently out of use.
Caution - This procedure must be done with the battery disconnected from the vehicle!
WARNING
• WARNING! Explosive gas , avoid ames and sparks . During charging, the battery should be placed in a ventilated area.
• Protect the unit from rain and moisture
• If the power cable is damaged it must be replaced by the manufacturer , its after sales or a similarly qualied person
to avoid hazard.
• Under no circumstances this appliance should be used to charge accu;ulators or non rechargeable batteries.
• Respect the connection sequence indicated .
• Product subject to separate collection , do not dispose in domestic waste .
• This appliance is not intended for use by persons (including children) with reduced physical , sensory or mental
capabilities, or lack of experience or knowledge, unless they could benit by through a person responsible for their
safety, supervision or instruction concerning use of the appliance .
• Do not open the device. Modications not performed by a manufacturer's technician leads to void the warranty .
• Check that the available voltage corresponds to the one indicated on the nameplate of the charger.
TROUBLESHOOTING
Anomalies Causes Remedies
The ammeter does not move. Power supply problem Check the power supply
Check the machine is switched to the charge
position
"Polarity reversal or clamp in short
circuit"
Check the fuses is intact
The battery is faulty Check with a voltmeter the voltage on the
terminals. If the voltage rises instantly at
more than 2.5V per element, the battery
may be damaged or sulphated.
Volage error (12 -24 V) Check the switch is on the correct selection
(12 or 24V)
Following intensive use, the machine has
switched off due to thermal protection to
cool down.
Wait for 15 min to allow cooling
The ammeter indicates more than 20A
whereas the selector adjustment is at the
minimum
The battery is deeply discharged Keep charging but only at a low output
Voltage error (12 - 24 V) Check the switch is set correctly (12 or 24V)
Some battery elements are in short-circuit Change the battery
The machine stops You are starting whilst in the “charge” mode
of the machine
Switch to the “start” position otherwise it
could damaged the machine.
A 12V battery is charged on the 24V output Put the switch on the 12V position
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gys START 300 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gys START 300 in the language / languages: English, German, French, Spanish as an attachment in your email.

The manual is 0,85 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info