625744

Gys START 300 Manual

7
Zoom out
Zoom in
Previous page
1/28
Next page
7
START 200 / 300
EN
Sealed battery
To charge a sealed battery, it is necessary to be extremely careful. The charge must be applied slowly whilst constantly
monitoring the battery voltage. It is recommended to stop the charge when the voltage (voltage charging court) reaches
14.4V for a 12V battery and 28.8V for a 24V battery. This voltage can be measured using a voltmeter or battery tester.
Charge
Once the charger is connected to the battery as recommended (see connection and disconnection),
For the START 200 and 300:
- Turn the switch to the CHARGE or BOOST 1 position according to the battery capacity.
Warning : In Boost 1 mode thermal protection might be activated at the beginning of the charge if the battery is deeply
discharged.
CHARGE (12-24V)
Start 200 53 - 240 Ah (11A)
Start 300 38 - 300Ah (10A)
After use follow the recommended instructions for disconnection.
Charging multiple batteries simultaneously
You can charge multiple batteries simultaneously connecting them in parallel. Connect the positive terminals to the red
clamp and the negative terminals to the black clamp. These batteries or group of batteries must all be the same voltage,
12 or 24V.
Charging in series is not recommended.
USE IN STARTING MODE
Precautions before use
• Do not disconnect the battery from the vehicle. Disconnecting the battery may result in loss of information and a
possible inability to restart.
Starting
Once you have connected the starter to the battery as recommended (see connection), it may be necessary to precharge
the battery to provide the energy needed for starting. To perform a precharge turn the switch on the "BOOST " position.
START 200 and 300 :
Instantaneously 5 min precharge
Start 200 35 - 40 Ah 40 - 80 Ah
Start 300 35 - 50 Ah 50 - 100 Ah
To perform the precharge set the switch to the "BOOST" position.
To start a vehicle turn the switch to the "START" position. Go to the vehicle driver side. By turning the key you activate
the starter function. This function must be stopped as soon the vehicle start. It is ideal to work with two people. The
one close to the START can turn the switch to the START position at the last moment and stops the device once the
vehicle has started.
If your engine does not start, wait 2 minutes between two start attempts. The attempt must last a maximum of 3 sec.
Nb: A vehicle that will not start can be a problem other than a battery in poor condition. It could come from many other
causes.
After use follow the recommended instructions for disconnection.
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gys START 300 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gys START 300 in the language / languages: English, German, French, Spanish as an attachment in your email.

The manual is 0,85 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info