625747

Gys NEOSTART 620 Manual

8
Zoom out
Zoom in
Previous page
1/32
Next page
8
NEOSTART 320 / 420 / 620
EN
USE IN STARTING MODE
Precautions before use
• Do not disconnect the battery from the vehicle. Disconnecting the battery may result in loss of information and a
possible inability to restart.
Starting
Once you have connected the starter to the battery as recommended (see connection), it may be necessary to precharge
the battery to provide the energy needed for starting. To perform a precharge turn the switch on the "BOOST 2" position
for the NEOSTART 320 and on the "BOOST" position for the NEOSTART 420 and 620.
NEOSTART 320 :
Instantaneously 5 min precharge
Neostart
320
12 V 35 - 60 Ah 60 - 120 Ah
24 V 35 - 45 Ah 45 - 90 Ah
NEOSTART 420 and 620 :
Instantaneously 5 min precharge
Neostart 420 35 - 80 Ah 80 - 160 Ah
Neostart 620 45 - 100 Ah 100 - 200 Ah
To perform the precharge set the switch to the "BOOST" position.
To start a vehicle turn the switch to the "START" position. Go to the vehicle driver side. By turning the key you activate
the starter function. This function must be stopped as soon the vehicle start. It is ideal to work with two people. The
one close to the NEOSTART can turn the switch to the START position at the last moment and stops the device once
the vehicle has started.
If your engine does not start, wait 2 minutes between two start attempts. The attempt must last a maximum of 3 sec.
Nb: A vehicle that will not start can be a problem other than a battery in poor condition. It could come from many other
causes.
After use follow the recommended instructions for disconnection.
PROTECTION
This device has been designed with maximum protection:
• The charging clamps are fully insulated.
• A fuse provides proctection against reverse polarity and short circuits :
- Neostart 420 and 620 : ref. 054547, 200A fuse (SIBA-V Fuse / open type)
- Neostart 320 : ref. 054639, 150A fuse (Littlefuse BF1 / 32V type)
• A circuit breaker on the front panel provides protection against overload or starting the battery with the switch on the
"Charge" position. If it breaks, a manual reset is required.
• Thermal protection is provided by a thermostat (cooling approximately 1/4h). The green light goes off in case of
overheating.
SULPHATED OR DAMAGED BATTERIES
NEOSTART does not detect sulphated or damaged batteries.
• Your battery is deeply damaged if in charge, the ammeter needle deects rapidly to very high intensities. Your battery
is permanently out of use.
• In the case of a sulphated battery: turn the device on the highest speed "BOOST" for the NEOSTART 420 and 620
or "BOOST 2" for the NEOSTART 320 and regularly monitor if the ammeter shows a charging current. As soon as the
charging current increases, put the switch onto the suitable charging mode for the battery. If there is no improvement
after 5 hours, the battery is permanently out of use.
Caution - This procedure must be done with the battery disconnected from the vehicle!
… 8 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gys NEOSTART 620 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gys NEOSTART 620 in the language / languages: English, German, Dutch, French, Spanish as an attachment in your email.

The manual is 0,95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info