625745
9
Zoom out
Zoom in
Previous page
1/32
Next page
9
NEOSTART 320 / 420 / 620
EN
WARNING
WARNING! Explosive gas , avoid ames and sparks . During charging, the battery should be placed in a ventilated
area.
• Protect the unit from rain and moisture
• If the power cable is damaged it must be replaced by the manufacturer , its after sales or a similarly qualied person
to avoid hazard.
• External fuse can be replaced and the circuit breaker can be engaged by the user.
• Under no circumstances this appliance should be used to charge accu;ulators or non rechargeable batteries.
• Respect the connection sequence indicated .
• Product subject to separate collection , do not dispose in domestic waste .
• This appliance is not intended for use by persons (including children) with reduced physical , sensory or mental
capabilities, or lack of experience or knowledge, unless they could benit by through a person responsible for their
safety, supervision or instruction concerning use of the appliance .
• Do not open the device. Modications not performed by a manufacturer's technician leads to void the warranty .
• Check that the available voltage corresponds to the one indicated on the nameplate of the charger.
TROUBLESHOOTING
Anomalies Causes Remedies
The ammeter does not move.
Power supply problem
Check the power supply
Check the machine is switched to the charge
position
"Polarity reversal or clamp in short
circuit"
Check the fuses is intact and if the circuit-
breaker is engaged
The battery is faulty
Check with a voltmeter the voltage on the
terminals. If the voltage rises instantly at
more than 2.5V per element, the battery
may be damaged or sulphated.
Volage error (12 -24 V)
Check the switch is on the correct selection
(12 or 24V)
Following intensive use, the machine has
switched off due to thermal protection to
cool down.
Wait for 15 min to allow cooling
The ammeter indicates more than 20A
whereas the selector adjustment is at the
minimum
The battery is deeply discharged Keep charging but only at a low output
Voltage error (12 - 24 V) Check the switch is set correctly (12 or 24V)
Some battery elements are in short-circuit Change the battery
The machine trips
You are starting whilst in the “charge” mode
of the machine
Switch to the “start” position otherwise it
could damaged the machine. Reset the
circuit breaker
A 12V battery is charged on the 24V output Put the switch on the 12V position
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gys NEOSTART 320 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gys NEOSTART 320 in the language / languages: English, German, Dutch, French, Spanish as an attachment in your email.

The manual is 0,95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info