625745

Gys NEOSTART 320 Manual

7
Zoom out
Zoom in
Previous page
1/32
Next page
7
NEOSTART 320 / 420 / 620
EN
clamp and nally the black clamp.
USE IN CHARGING MODE
Precautions before use
• Choose a sufciently ventilated area
• Remove the caps on the battery (if any) and make sure the water level (electrolyte) is sufcient. Otherwise add
deionized water and carefully clean the battery terminals.
• Check that the battery capacity in amps/hour and voltage in volts are compatible with your charger.
Monitoring and state of charge
CAUTION: Charging batteries require monitoring and the charge will only stop when the operator switches the Neostart
to "OFF" or disconnects the device from the mains.
When the battery is charged, the liquid (electrolyte) in the battery starts to "boil". It is recommended to stop the charge
at the beginning of this phenomenon to avoid damaging the battery.
Moreover if the battery is connected to a vehicle, a prolonged load unsupervised can damage the vehicle electronics. As
well as sulphated battery refusing the load will cause the same risks directly from connecting the charger to the battery.
The end of the load is detected by the needle position of the ammeter when it is between 0 and 10A or by a time greater
than 10H load.
Sealed battery
To charge a sealed battery, it is necessary to be extremely careful. The charge must be applied slowly whilst constantly
monitoring the battery voltage. It is recommended to stop the charge when the voltage reaches 14.4V for a 12V battery
and 28.8V for a 24V battery. This voltage can be measured using a voltmeter or battery tester.
Charge
Once the charger is connected to the battery as recommended (see connection and disconnection),
For the NEOSTART 320 :
- Turn the switch to the CHARGE or BOOST 1 position according to the battery capacity.
Warning : In Boost 1 mode thermal protection might be activated at the beginning of the charge if the battery is deeply
discharged.
CHARGE (12-24V) BOOST 1 (12-24V)
Neostart 320 40 - 160 Ah (11A) 90 - 400 Ah (27A)
For the NEOSTART 420 and 620 :
- Turn the switch to the CHARGE 1 or CHARGE 2 position according to the battery capacity.
CHARGE 1 (12-24V) CHARGE 2 (12-24V)
Neostart 420 25 - 90 Ah (6A) 90 - 300 Ah (20A)
Neostart 620 45 - 140 Ah (10A) 140 - 450 Ah (30A)
After use follow the recommended instructions for disconnection.
Charging multiple batteries simultaneously
You can charge multiple batteries simultaneously connecting them in parallel. Connect the positive terminals to the red
clamp and the negative terminals to the black clamp. These batteries or group of batteries must all be the same voltage,
12 or 24V.
Charging in series is not recommended.
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gys NEOSTART 320 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gys NEOSTART 320 in the language / languages: English, German, Dutch, French, Spanish as an attachment in your email.

The manual is 0,95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info