665824
17
Zoom out
Zoom in
Previous page
1/64
Next page
17
NEOPULSE 400
EN
SPECIFICATIONS FOR THE INTERCONNECTION CABLE (WIRE FEEDER INTO POWER SOURCE)
1
2
3
4
5
6
7
8
9
10
A
C
B
D
E
F
G
H
J
K
A
B
D E
F G
H J
K
C
53056
Y
Z
A
B
+24V
M24V
M48V
+48V
COOLING UNIT
This machine may be connected to a NEOCOOL cooling system for the cooling of the water torch. The recommended cooling system unit is auto-
matically detected by the TIG 300 DC. To deactivate the cooling unit, check the wire feeder’s manual. For installation, refer to the cooling unit’s
instruction manual.
Make sure that the cooling unit is switched off before disconnecting the inlet and outlet hoses for torch liquid.
The coolant is harmful and irritates the eyes, the mucus membranes and the skin. Hot liquid may cause burns.
CONNECTION THE INTERCONNECTION CABLE
Before connecting the interconnection cable, cut the power supply using the interrupor behind the machine .
Do not connect the electrode holder when using the machine in MIG / MAG mode.
• MIG / MAG WELDING
BACK OF THE DEVICE FRONT OF THE DEVICE DESCRIPTION
1 Control
2 Gas
3 Power
4
Cooling
5
• MIG / MAG WELDING (POLARITY REVERSAL)
Be cary of the welding current polarity ! Certain types of wire must be welded with a negative polarity. In this event, a polarity
reversal cable must be used (optional, ref. 033689).
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gys NEOPULSE 400 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gys NEOPULSE 400 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 5,58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info