628571
9
Zoom out
Zoom in
Previous page
1/56
Next page
The pump is not suitable for sw imming pools. Electric
installation may be performed only by a specialist. The pump
shall be supplied through installation of a device protecting it
against insufficient current.
Do not allow the pump to be operated w ithout w ater and
w ithout w ater supply. Otherw ise the pump service life w ill be
endangered and the engine may be damaged..
Never envelop the pump head engine w ith a blanket or a
scarf to prevent freezing of w ater in cold w eather.
Do not use pump at outside temperatures over 40 °C or under
0 °C and w ith w ater temperature over 35 °C.
The pump shall never be used for other liquids than w ater.
Do not use sand containing water, the sand may destroy
sealing.
Read carefully Operation Manual before installation and
putting into operation. The persons not acquainted w ith the
pump operation should carefully read the relevant Operating
Manual for operation and maintenance before putting the
pump into operation, in order to prevent damaging the pump
from the very beginning.
The user is responsible for third persons on the w orkplace.
The pump may be put into operation exclusively w ith a cable
or rubber electric extension cord type H07RNF, according to
standard DIN 57282 or DIN 57245.
The pump shall not be lifted, transported or fixed by pulling
the electric connecting cable.
Should cable or a plug be damaged due to external impacts,
the cable shall not be repaired! The cable shall be replaced
by a new cable.
This w ork may be performed only by an electrician-specialist.
Make sure that the connecting lines to electric sockets are
protected against flooding and moisture.
It is necessary to check before use if the connecting cable
and electric plug are in order. The pump shall be placed on
flat, stabile and horizontal plane.
Pull the plug out of the socket before any w ork.
The user is responsible for observation of local regulations
related to safety and built-in system.
Before every use check the device visually. Do not use the
device if the safety equipments are damaged or w orn out.
Never put the safety equipment out of operation.
The device shall be used exclusively for the purpose given in
thie Operation Manual.
You are responsible for safety in the w orking region.
If the pump is faulty, the repair shall be performed exclusively
in the repair shops authorized to do so. Only original spare
parts may be used
It is necessary to take relevant measures for preventing the
placing of the device w ithin the reach of children.
Before putting into operation it is necessary to find out by a
professional test if all required electric protection measures
are available.
During operation of home w ater station nobody may stay in
the medium being repumped.
Prevent the home w ater station to be exposed to direct w ater
current.
The ow ner is responsible for observation of safety provisions
and of provisions for built-in system.
(Consult the electrician-specialist, if necessary)
The pump is not suitable for long-term operation (e.g.
as a circulation pump in ponds or brooks). The service life
gets shorter accordingly if the pump is used in this manner. In
such a case, use a sw itching clock and ensure sufficiently
long breaks betw een the operating cycles.
The pump must not be connected to the existing water
supply system as equipment increasing the pressure.
The pump is not suitable as a long-term, automatic
safety against overflow of tanks and w ells or for control of
underground w ater in cellars.
Do not leave the pump unattended to prevent damage
as a result of any faulty function. Alw ays disconnect the pump
from netw ork if not used.
The producer does not guarantee for any damage caused by
unqualified installation or unprofessional operation of the
pump.
The equipment must be regularly inspected and its faultless
condition needs to be checked.
Before each putting into operation, the pump must be visually
inspected for any damage (especially on the pow er supply
cable and plug). Using a damaged pump is strictly prohibited.
Electrical safety:
DANGER! Electric shock!
Danger of electric current accident!
Pull the plug out of the network before filling, after
putting out of the operation, when repairing the failures.
Operation is permitted only on connecting lines
furnished with the insufficient current switch (PRCD)!
Please ask the electrician-specialist.
The data on the type label shall comply w ith the electric
netw ork data.
Protect the cable against heat, oil and sharp edges.
For Austria
The electric connecting line in Austria shall comply w ith the
ÖVE-EM 42, T2 (2000)/1979 § 22 pursuant to 2022.1.
According to this regulation the pumps may be operated for
use in sw imming pools and garden lakes only via separating
transformer.
Please consult your electric professional company.
For Switzerland
In Sw itzerland the devices used outside are different in
various locations, and shall be connected via insufficient
current protection sw itch.
General Instructions:
Before every use perform visual inspection to make sure
that the pump, particularly the netw ork cable and the plug are
not damaged.
A damaged pump shall not be used.
In case of a failure the pump shall be checked by the GÜDE
Service or by an authorized electrician-specialist.
Do not expose the pump to rain and do not operate it in w et
or moist environment. The pump must not w ork w ithout w ater,
therefore make sure that the end of the suction hose is
permanently in the medium to be repumped.
Before every putting into operation the pump shall be filled
w ith the liquid to be repumped up to the overflow !
When pump is used for supplying the w ater in a house, the
local regulations of authorities for w ater and w aste w ater
management shall be observed.
The provisions of DIN 1988 shall also be observed.
What to do in Emergency?
Introduce reasonable first aid measures as necessary
according to the injury, and ask for qualified medical help as
soon as possible.
Secure the injured against any other damage and secure
resting conditions for him.
Use in accordance with the Conditions
The home w ater station is designated exclusively for pumping
clean w ater for the purpose or w ater supply in the house, in
the garden, in the courtyard and in agriculture. Should the
provisions of generally applicable regulations and provisions
in this Manual be not observed, the manufacturer cannot be
responsible for damages.
Remaining Dangers and Protection Measures
Electric Remaining Dangers
Danger
Description
Protection Measures
Direct
electric
contact
Electric shock
Insufficient current sw itch FI
9
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gude JA 200 M 230 V 94197 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gude JA 200 M 230 V 94197 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 1,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info