628427

Gude GP 4600 VF Manual

10
Zoom out
Zoom in
Previous page
1/42
Next page
If there is a fault, have the pump checked by a GÜDE
servicing or by an authorised electrical engineer.
Do not expose the pump to rain and do not use it in wet or
moisture conditions.
To avoid the pump dry run, make sure that the end of the
suction hose is always in the medium to be transported.
Before every outing in operation, fill the pump with liquid up to
the spill!
When using the pump for domestic water supply, always
observe the local regulations of water management
authorities and the waste water drainage.
In addition, observe the provisions of DIN 1988.
The pump is not suitable for long-term operation (e.g.
as a circulation pump in ponds or brooks). The service life
gets shorter accordingly if the pump is used in this manner. In
such a case, use a switching clock and ensure sufficiently
long breaks between the operating cycles.
The pump must not be connected to the existing water
supply system as equipment increasing the pressure.
The pump is not suitable as a long-term, automatic
safety against overflow of tanks and wells or for control of
underground water in cellars.
Do not leave the pump unattended to prevent damage
as a result of any faulty function. Always disconnect the pump
from network if not used.
The producer does not guarantee for any damage caused by
unqualified installation or unprofessional operation of the
pump.
The equipment must be regularly inspected and its faultless
condition needs to be checked.
Before each putting into operation, the pump must be visually
inspected for any damage (especially on the power supply
cable and plug). Using a damaged pump is strictly prohibited.
Emergency Action
Take the measures of first aid according the kind of injury and
get a qualified medical aid fast..
Protect the injured person before another detriment and calm
him/her down.
Assigned Use
The pump is designed for pumping clean water only to supply
the home with water and to use it at home, in garden,
courtyard and for fields. The manufacturer should not be held
liable for non-observance of the general regulations and
provisions in this manual.
Residua Hazards and Protective Action
Electrical Residua Hazards
Hazard Description Protective Action
Direct
electrical
contact
Electrical shock Stray current switch FI
Indirect
electrical
contact
Electrical shock
by medium
Stray current switch FI
Disposal
Waste disposal instructions according to the picturegraphs on
unit or on packaging . Meaning of the symbols to be found in
Chapter “Symbols on Unit”.
Operator Requirement
The operator shall read the instruction manual carefully
before using the unit.
Qualification
No special qualification is required for use of the unit except
for detailed direction by a professional.
Minimum Age
Only persons above 16 years of age are allowed to work with
the unit.
Exempted from the provision is the use of the juvenile
trainees if they work in the course of their professional
training with an aim to obtain the skill under trainer
supervision.
Training
Use of the unit requires adequate lesson by a professional or
the use of the manual only. Special training is not required.
Technical Data
Connection 230 V~50 Hz
Motor output P1 1100 W (P1)
Max. suction head 8 m
Max. pumped quantity 4600 l/h
Max. pumping height 45 m
Suction connection 1’’ IG
Protection type IP X4
Water temperature 35 °C
Approximate weight 9 kg
Product number 94209
Transportation and Storage
No water should be left in the unit when stored in
winter because the unit would get impaired by effect of frost.
For any transportation, the pump shall be disconnected from
the mains!
Initial Operation Safety Instructions
Caution: The pump should not run dry.
Do not use the pump for drinking water pumping!
Regarding the use of the pump (water facilities etc.) the user
shall be liable before third persons. Operate on connections
with the stray current switch (FI-switch)!
Before putting the unit in operation, a competent electrician
should check whether required safety measures are available.
A socket should be used for electrical connection.
The voltage should be checked. Technical data on the plate
should coincide with the voltage in the system.
If the pump is used in ponds, wells etc. and in other water
management facilities it is essential to observe, the standards
effective in the countries, in which the pump is operated.
Electrical pumps for works outdoors should be equipped with an
electrical cable of rubber, type H07RNF, as required by
standards DIN 57282 or DIN 57245.
If the pump is in operation, persons or animals should
not be allowed to stay or to soak in the liquid to be
transferred (e.g. pools, cellars etc.).
Temperature of the liquid to be pumped out should not be in
excess of +35°C. The extension cables shall be of rubber
type H07RNF only, as required by standards DIN 57282 or
DIN 57245. Never touch the cable of electrically connected
pump, do not lift or push it by the cable. Remember that the
socket should be at a safe distance from water and moisture
so that the plug is protected against moisture.
10
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gude GP 4600 VF at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gude GP 4600 VF in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 0,66 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info