623628

Gude DHH 1050-7 T ECO 01955 Manual

13
Zoom out
Zoom in
Previous page
1/119
Next page
Introduction
Dear Customer,
We strongly recommend that you become familiar with this operating instructions. It is in the interest of your health
that would be put at a risk unless your knowledge of this manual is profound. Presenting you this manual, we wish
that your work with the product you have purchased is made as easy as possible. It is necessary to observe the
instructions contained herein for the machine to work to your complete satisfaction. Our objective is to improve the
products continuously and for this reason, we reserve changes.
We urgently discourage you from putting the machine in operation without you having got
familiar with the contents of this manual!!
Precautionary Instructions and Accident Prevention
General
For safety reasons, precautionary instructions contained in this manual and instructions on the machine regarding
operation, maintenance and repairs should be respected and observed.
Operators
Any use of the cleaving machine may entail hazards. Therefore, only well-instructed and experienced
persons should be allowed to handle the machine and to work on it. Operators should be required to wear
tight-fitting clothes and protective shoes. No persons bellow 18 years of age should be allowed to work
with the machine. It is permitted however, to have people above 16 yrs of age working with the machine
provided that it is necessary for educational reasons and professional supervision is guaranteed.
Working Area
It is an imperative for a safe cleaving job that the floor in the working area is flat and firm-based and sufficient
freedom of movement is secured. Ways for bringing and removing the machine in/from the area should be free of
any disturbances. Sufficient lighting should be provided in the working area.
Job Preparation
When doing repairs or maintenance or when leaving the cleaning machine unattended, the current supply should
be cut off by pushing the red button on the switch and unplugging the machine. It is not sufficient to cut the
power supply off by mere switching off. GÜDE cleaving machines are always delivered with hardened cleaving
knives. However, light deformation of the cleaving knife cutting edge may arise in result of cleaving wood with
unexpected foreign bodies in it – concrete, steel etc.- and whetting or filing must remove it. The knives sharpness
maintenance will increase working capacity.
TIP: Grease the cleaving knives every now and then (for problem wood).
Safety devices (primarily two-lever control) must be checked on prior to being put in operation for
the first time and the function must be examined.
Warning! Make sure that cleaving bench us safely fitted to the machine prior to any starting the
operation.
• Keep the place of your work clean at all times and remove any wood remains fallen down.
• Keep in mind that wood is a natural raw material and may get out of control when being split
(unexpectedly thrown-off wood pieces)
• Safety shoes should always be worn.
• Keep your hands outside the wood face or splitting knife entry at all times.
• Faces of the split wood must be rectangular if possible so that wood stays safely on the supporting table
and cannot slip to the side.
• Safety equipment of the appliance must not be disassembled or put out of operation.
• Remove wood, wood waste and bark from the place of appliance operation.
• Check the feeder cables. Do not use feeder cables that are faulty.
• Check whether the two-handed operation works properly before putting the appliance into operation.
• Wear closefitting clothes. Remove jewels, rings and wristwatch.
• Wear protective clothes.
• Attention during work: Risk of injury to fingers and hands caused by the splitter.
• All the protective equipment and covers must be fitted to the appliance and function faultlessly
when working with the appliance.
• Use an appropriate supporting tool for splitting heavy or big pieces.
13
… 13 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gude DHH 1050-7 T ECO 01955 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gude DHH 1050-7 T ECO 01955 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 8,42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info