706671
7
Zoom out
Zoom in
Previous page
1/42
Next page
-7-
There are 2 ways of connecting the rear camera to the car/truck’s electronic system
1. Plug & play connection: via the adapter for the cigarette lighter, 12/24 V systems.
2. (optional) Reverse signal detection: immediately to the car/truck’s rear signal light system (12~24
V) via the red + power cable. The red wire should be connected to the + voltage of the car/truck
reverse signal/light power supply. If the reverse signal is connected to the reverse signal light
power, the front and rear camera will switch ON/OFF automatically when you select the reverse
gear from your car’s gear box or automatic transmission box. Once the gear is in rear-position, the
camera will switch to rear camera automatically and the LED lights will turn on*.
Note: Connect the red wire with the contact clip. Put the car/truck wire in the groove of the clips and
the cable wire in the groove with the conning rib, and push it hard to connect.
* Use a tool to lift the edges of the rubber window sealing and molding and push the rear and front
camera connection cables inside.
* When using the rear camera inside the car, we advise to
add the light cover on top of the LED lights to have no
reections or disturbances.
Attention!
If there is no “Reverse signal/light” wire or if it is unavailable, you should not connect the red cable
but consult your garage/car manufacturer for more info.
Note: To avoid distortions make sure that the cables are laid far away from the electronic systems
of the car/truck.
OPERATION
A. MODES
Attention: This menu will not work if Mass Storage mode is activated.
VIDEO RECORDING MODE
A camera icon is shown in the upper left corner of the display.
When the GUARDO DUAL DASHCAM is connected to your car’s power supply, it will start Video
recording as soon as the car engine is started. It will stop recording after the car is stopped.
When the GUARDO DUAL DASHCAM is not connected to the car’s power supply, press and hold
the button, and press the button to start recording. The unit will automatically be in
Video recording mode. Press again to stop recording and save the les automatically.
Loop recording: During recording, the device will save each video le every 1, 5 or 10 minutes
automatically. When the micro SD card is full, the device will delete the oldest video les
automatically one by one.
3.5m
Cigarette plug cable
6m
Power line
Reverse signal red + wire
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Guardo DUAL DASHCAM DDC-200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Guardo DUAL DASHCAM DDC-200 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 3,19 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info