633020
12
Zoom out
Zoom in
Previous page
1/16
Next page
12
- DOUBLE LOCKING.
In the first 5 seconds after the system is armed and the doors lock press the lock button
on the handset a second time and the double locking if connected will be set this is
confirmed by a second tone and flash of the indicators.
- COMFORT CLOSING.
If this function is ENABLED, on the vehicles equipped with this function, the window
closing occurs automatically. If window closers are fitted or you wish to isolate the ultrasonic
sensors, it is possible to stop the windows closing by pressing the handset LOCK
BUTTON a second time until the desired position is reached or until the windows are fully
closed.
- ANTI-HIJACK (Available only with GT884N).
This function allows the user to activate the engine imobiliser if they are forced to leave it
. The operation occurs only by the GT884N handset in “LINK-AUTOMATIC TRANSMISSION”
mode.
1 - With the ignition on the LED illuminates constant RED to indicate that the anti-hijack
procedure is activated. If the LINK signal is missing for more than 30 seconds the system
enters the anti-hijack phase.
2 -The LED illuminates constant GREEN.
3 - After 15 seconds the indicators start flashing.
4 - After other 15 seconds the system emits an alarm cycle with a duration of 30 seconds.
If the ignition stays on another alarm cycle is generated.
5 - When the ignition is off the engine immobilisation is activated and it sops the vehicle
starting. An alarm cycle will be generated by attempting to start the vehicle.
6 - To come out from the anti-hijack state, from any phase, it is necessary to have the
handset in LINK- AUTOMATIC TRANSMISSION and approach the vehicle. The operation
will be confirmed by two flashes of the indicators, two Beeps of the siren and by the LED
switching off.
- PROTECTION
When the system is armed the check status LED switches on constant, after 30 seconds
the LED starts to flash. The ignition key, boot/bonnet protection are active 5 seconds
after arming, while the door pin switch and the additional input and the wires cut (only
for GT915/916) are only active when the check status LED flashes.
- PANIC FUNCTION (only with GT888).
- Press the “PANIC” button with the system fully armed(LED FLASHING)the indicators
flash and the siren sounds.
- Press a second time the “PANIC” button to stop the panic.
- BACKUP BATTERY RECHARGE.
The device is equipped with internal battery to provide the siren with power if the battery is
disconnected during the armed condition.For the siren battery to become fully charged
the system has to have been fully connected to the vehicle for 24 hours.
- EMERGENCY DISARMING.
In case of emegency (i.e. handset battery discharged) it is possible to deactivate the
system by inserting the contacts on the remote control supplied into the RECEPTACLE
that has been fitted.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for GT 915 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of GT 915 in the language / languages: English as an attachment in your email.

The manual is 0,35 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info