633020
8
Zoom out
Zoom in
Previous page
1/16
Next page
7.0 - SET FUNCTIONS
The system is equipped with a “SET FUNCTIONS” which allows to program and customize
the alarm following to the user needs.
To access to the SET FUNCTIONS:
1 - The alarm must be disarmed.
2 - Switch the vehicle ignition key on, place the GT888 handsets contacts to the receptacle
and check that 5 quick beeps are emitted and the RED LED will switch on constant. The
alarm is in SET FUNCTIONS mode. Switch the ignition key off.
3 - After 5 seconds starting from the function No.1 a sequence of LED beeps corresponding
to the function are emitted, the LED flashes can be GREEN or RED to indicate the function
state. The sequential cycle of the LED flashes (from the function No.1 to No.7) is repeated
twice and after you come out automatically from the SET FUNCTION.
4 - To select a function switch on-off the ignition in conjunction with the relative signal, the
LED switches on constant.
5 - Within 10 seconds change the the function by pressing the ON/OFF handset button.
The change is confirmed by the change of the LED colour and by a beep. After 10 seconds,
starting from the last function selected, the function sequence will start again.
To come out from the SET FUNCTIONS:
Wait untill the end of the signals and place the GT888 handsets contacts to the receptacle
(not during the Function No. 1 - HANDSETS SELF-CODING). The end of the sequence is
confirmed by the Led switching off and by 5 beeps. In the “FUNCTIONS TABLE” are the
functions which can be selected.
SET FUNCTIONS emergency disarming procedure.
If the GT888handset-electronic key lost it is possible to enter the SET FUNCTIONS:
A - With the alarm disarmed disconnect the power supply and wait 3 minutes.
B - Short-circuit the RECEPTACLE/LED contacts.
C - Connect the power supply again.
D - Switch on and off the vehicle ignition key four times and check that 5 quick beeps are
emitted and the LED is constant RED to confirm you have entered the SET FUNCTIONS.
E - Remove the short-circuit between the RECEPTACLE/LED contacts before carrying out
the selection of a function that is required.
8
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for GT 915 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of GT 915 in the language / languages: English as an attachment in your email.

The manual is 0,35 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info