ENGLISH
31
SETTINGS
____________________________________________________________________________
The channel position set-up sub-menu »2:
??
«
The receiver is already pre-programmed for the current channels of many satellites. In most cases,
no correction will be required.
However, new channels are continuously being added, or transmission frequencies being changed.
The current status of the transmission frequencies can be called up via the Teletext pages of various
channels (e.g. SAT 1 or 3SAT), via Internet, or can be found in a current satellite TV magazine.
You may then programme these channel positions in the "Channel position set-up" sub-menu and
you will have access to the image and sound settings of the individual channel positions.
1 Switch the satellite receiver on. Press the »Ǻ« button followed by the »2 « button to display the
channel position set-up sub-menu »2:
//
«.
Key to symbols:
??
A/B 001 Reception unit A or B (INPUT A or B) of the satellite
receiver/ channel position number
ʐʐ
11. 494 GHZ Transmission frequency of the selected satellite channel
$
H – A LNC settings:
Polarization H (horizontal) V (vertical)
–
22 kHz switching signal off
~
22 kHz switching signal on
Satellite selection A/B
ʀǁ
7.02 MHz 7.20 MHz Left/right sound carrier
ǁ
~
PANDA BW 1 PANDA, 50US (50µs), J17
(Deemphasis/noise reduction)
Bandwidth setting (BW 1, 2, 3 or 4)
(
– /
✓ Favourite programme marks – off, ✓ on
{
1
/
2
Contrast level 1 or 2
/
–––
Decoder settings
=
+ / –
Video polarity (positive/negative)
Ǻ
Exit menu without saving
OK Save and exit menu
??
A 003
ʐʐ
11. 494 GHZ
$
H – A
ʀǁ
7.02 MHz 7.20 MHz
ǁ~ PANDA BW 1
((
–
{
1
//
– – –
= +
Ǻ / OK
