ENGLISH
35
SETTINGS
_______________________________________________________________________________
LNC oscillator frequency ($)
The receiver is pre-programmed for the following LNC oscillator frequencies:
– A1 22 KHz off: 09 . 750 GHZ /~A1 22 KHz on: 09 . 750 GHZ
– B1 22 KHz off:: 09 . 750 GHZ /~ B1 22 KHz on: 09 . 750 GHZ
– A2 22 KHz off:: 09 . 750 GHZ /~A2 22 KHz on: 09 . 750 GHZ
– B2 22 KHz off:: 09 . 750 GHZ /~ B2 22 KHz on: 09 . 750 GHZ
These can be changed if you use an LNC with a different oscillator frequency.
1 Select the oscillator frequency to be changed using the »
,,
or
..
« button.
2 Enter the new oscillator frequency using the »1… 0 « buttons, or change it step by step using the
»
;;::
« buttons.
Note:
If you are using a number of LNCs, all the oscillator frequencies will need to be checked and,
if necessary, "re-entered".
LNC voltage supply on/off ( $%)
The LNC voltage supply is switched on as a factory setting. The receiver supplies power to the
satellite aerial.
If your receiver is connected together with other satellite receivers to a joint aerial (a so-called single
cable solution in the master distribution), you will need to switch off the LNC voltage supply ($
%
–
).
1 Use the »
;;::
« buttons to switch the LNC voltage ”off” ($
%
–
) or ”on” ($
%
✓ ).
2 Press the »OK« button to save the setting.
– The main menu appears on the screen again.
