ķ
8
Radio
ǺǺ When the
Q
TUNING Wbutton is pressed constant-
ly, the system switches automatically into
rapid motion.
3. Set the frequency in the desired direction
with the Q
TUNING W buttons. With
Q
TUNING you increase the frequency for
FM by 50 kHz each time, for AM by 1 kHz
each time. With
W
TUNING you reduce the frequency by the
same amount each time.In the display, you
see e.g. »MAN 92.70«.
ǺǺ If the set station/RDS channel in the selected
range, e.g. » FM I « is already stored under a
station button, “M” and the corresponding
number, e.g. » M3 « for memory position 3.
4. If you wish to store the set station under a
station button, proceed as described in the
section “Station buttons” (see page 7).
5. Ending manual frequency settings: Press the
¢¢
RADIO button briefly.
ǺǺ Manual frequency setting is ended automati-
cally if you do not push any buttons for
60 seconds.
2.
By pressing one of the
Q TUNING W
buttons briefly, you can start the search in
the desired direction. The frequency can be
seen in the display e.g. »99.40«. When a
station with name identification is found,
you see the identification in the display.
Otherwise the frequency display remains.
ǺǺ If the set station/RDS channel in the selected
range, e.g. » FM I «is already stored under a
station button, “M” and the corresponding
number is shown in the display, e.g. » M3 « for
memory position 3.
3. If you wish store a set station under a station
button, proceed as described in the “Station
buttons” section (see page 7).
Manual frequency setting
Select the 1st range with the
¢¢
RADIO button:
»FM I«, »FM 2«, »FM 3« or »AM« or »LW«.
2. Press one of the
Q TUNING W buttons until you hear two
signal tones and »MAN ...« can be seen
together with the current frequency setting,
e.g. »MAN 100.60«.
Calling up a stored station/RDS channel:
Select a range: FMl, FM2, FM3, AM or LW.
Press the station button briefly.
ǺǺ The memory contents of the station buttons
remain, even when the operating voltage is
disconnected.
Setting the station/RDS channel with
station search
Select the 1st range with the
¢¢
RADIO button:
»FM I«, »FM 2«, »FM 3« or »AM« or »LW«.
The IS operating mode must be switched on
to start a search in the FM range (see page 7).
To do this, press one of the Q
TUNING
W buttons until
»IS « and then »IS OFF« appears briefly.
ǺǺ The search in the FM range works at two sen-
sitivity levels. In the first run, the search for
stations in the reception area with high field
strength (local stations), in the second run
for stations with low field strength (long
distance reception).
ǺǺ For station searches in the FM range, first the
LW and then the AM band is searched.
