157243
19
Zoom out
Zoom in
Previous page
1/20
Next page
PROBLEM POSSIBLE CAUSE REMEDY
Radio Reception
The STEREO indicator flashes. The signal is too weak. Adjust the antenna.
Severe hum or noise The signal strength is too weak. Adjust the antenna.
The TV or VCR is too close to the stereo system. Separate the stereo system from the TV or VCR.
Connect an external antenna for better reception.
Cassette Deck Operation
CANNOT RECORD” is displayed. No cassette in the cassette deck. Insert a blank cassette into the cassette deck.
The small tab has been broken.
Put a piece of clear adhesive tape over the opening.
Recording or playback cannot be made Dirty tape heads. See section on cassette deck maintenance.
or there is a decrease in audio level. Magnetic build-up in the record/playback head Use demagnetizing cassette
Excessive wow or flutter, or sound drop-out. Contamination of the capstans or pressure rollers. See section on cassette deck maintenance.
CD Player Operation
NO DISC” is displayed. The disc is inserted upside down. Place CD with printed side up.
Moisture condensation.
Wait until lens has adjusted to the room temperature
There is no disc in the CD tray. Insert a CD.
The CD is dirty, badly scratched or warped. Replace or clean the CD.
General
Set not working. Set does not react when buttons are pressed.
Press ON/OFF
y
to switch the unit off, then switch it on
again. Or, unplug the AC power plug from the
wall outlet, then plug it in again.
No or poor sound. Volume is not turned up. Adjust Volume.
The headphones are connected. Disconnect the headphones.
Speakers are not connected or are connected Check that the speakers are connected correctly.
wrongly.
Make sure that the stripped speaker wire is clamped.
Clock blinking. There has been a power interruption. Reset the clock.
Remote control has no effect on the set. The distance to the system is too large. Reduce the distance.
Batteries are inserted incorrectly. Insert the batteries correctly.
Batteries are empty. Replace the batteries.
Wrong sound source is selected. Select the sound source before pressing the
function button, (PLAY, PREV/NEXT, etc.)
PRESS DEMO TO EXIT” is displayed. Demo mode is switched on.
Press ON/OFF
y
or DEMO to switch off demo mode.
TROUBLESHOOTING
35
M27 page 35
GB
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING : Under no circumstances should you try to repair the set yourself, as this would invalidate the guarantee.
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Grundig m 27 c at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Grundig m 27 c in the language / languages: English as an attachment in your email.

The manual is 1,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info