157243
4
Zoom out
Zoom in
Previous page
1/20
Next page
General Information
The typeplate is located at the rear of the set.
Recording is permissible if copyright or other
rights of third parties are not infringed.
1 All unnecessary packaging material has been
omitted. We have done our utmost to make
the packaging easy to separate into three
mono-materials:
– cardboard (box)
– expandable polystyrene (buffer)
– polyethylene (bags, protective foam sheet).
Please observe the local regulations
regarding the disposal of these packaging
materials.
2 Your set consists of materials which can be
recycled and reused if disassembled by a
specialized company. Please follow local
regulations on recycling your old set.
3 Do not dispose off dead batteries with your
household waste. Dispose off batteries
according to local regulations.
4 Note: Switching off the standby mode
overnight (remove the AC power cord from
the wall socket) will save energy.
5
The set is provided with a built-in ventilator.
To prevent overheating, this ventilator will be
switched on when the unit reaches a certain
temperature.
INTRODUCTION
20
M27 page 20
GB
Safety Information
Before operating the system, check that the
operating voltage indicated on the typeplate (or
the voltage indication beside the voltage selector)
of your system is identical with the voltage of your
local power supply. If not, please consult your
dealer. The type plate is located at the rear of
your system.
When the system is switched on, do not move it
around.
Place the system on a solid base (e.g. a cabinet).
Place the system in a location with adequate
ventilation to prevent internal heat build-up in your
system.
Do not expose the system to excessive moisture
(e.g. dripping or splashing), rain, sand or heat
sources.
Under no circumstances should you repair the unit
yourself, as this will invalidate the warranty!
If the system is brought directly from a cold to a
warm location, or is placed in a very damp room,
moisture may condense on the lens of the CD unit
inside the system. Should this occur, the CD player
will not operate normally. Leave the power on for
about one hour with no disc in the unit until normal
playback is possible.
Electrostatic discharge may cause unexpected
problems. See whether these problems disappear
if you unplug the AC power cord and plug it in
again after a few seconds.
To disconnect the system from the power supply
completely, withdraw the AC power cord from the
wall socket.
Accessories (Supplied)
Remote control transmitter
Batteries (2 x AAA size) for remote control
transmitter
AM loop antenna
FM antenna wire
AC power cord
Inserting the batteries into the
Remote Control
Insert the batteries (Type R03 or AAA) into
the remote control transmitter as shown in the
battery compartment.
To avoid damage from possible battery
leakage, remove dead batteries or batteries
that will not be used for a long time. For
replacement use type R03 or AAA batteries.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Grundig m 27 c at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Grundig m 27 c in the language / languages: English as an attachment in your email.

The manual is 1,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info