574850
15
Zoom out
Zoom in
Previous page
1/20
Next page
15
MAINTENANCE AND CLEANING _________________
Before all maintenance and cleaning opera-
tions, remove the plug of the appliance or turn
off or remove the fuse!
Service your hood periodically!
Service is also required to prevent burning of
oil filter besides obtaining better performance
and better efficiency.
Cleaning the comfort panels
7
Pull the comfort panels to open them.
7
Disconnect the panel from the hood canopy
by sliding the fixing pin lever.
7
The comfort panel must never be washed in
a dishwasher.
7
Clean the outside using a damp cloth and
neutral liquid detergent.
7
Clean the inside as well using a damp cloth
and neutral detergent; do not use wet cloths
or sponges, or jets of water; do not use
abrasive substances.
7
When the above operation has been
completed, hook the panel back to the
hood canopy and close it by turning the
knob in the opposite direction.
Metal grease filter
Filters can be washed in the dishwasher.
Metal filters need to be washed every time
a drop-symbol appears in the display or at
least every 2 months. Hood shall be cleaned
more often when it is used more frequently.
Alarm reset:
Press the “G” key for at least 2 seconds.
Cleaning the filters
7
Pull the comfort panels to open them.
7
Remove the filters one by one pushing them
towards the back side of the hood unit and
simultaneously pulling downwards.
7
Any kind of bending of the filters has to be
avoided when washing them. Before fitting
them again into the hood make sure that
they are completely dry. (The colour of the
filter surface may change throughout the
time but this has no influence to the filter
efficiency).
7
When fitting the filters into the hood pay
attention that they are mounted in correct
direction with the handles facing outwards.
7
Close the comfort panel.
Attention:
7
Remove the filters one by one pushing them
towards the back side of the hood and
simultaneously pulling downwards and
towards the center of the hood.
Carbon filter
This filter cannot be washed or regenerated.
It must be replaced when the C appears on
the display or at least once every 4 months.
The filter saturation alarm has to be activated
before.
Activating the alarm signal:
7
In the recirculation version hoods the filter
saturation alarm must be activated during
the installation or later.
7
Switch off the hood and the lighting.
7
Press the “E” key for about 5 seconds until
the last two segments of the motor LEDs are
lit on the display.
7
By releasing the “E” key the clock icon starts
to flash.
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Grundig GDK5782 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Grundig GDK5782 in the language / languages: English as an attachment in your email.

The manual is 1,77 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info