505521
13
Zoom out
Zoom in
Previous page
1/27
Next page
6
GROUND ZERO
Remote control
1
Power button
11
Preset 1 / Pause
Preset 2 / Repeat
Preset 3 / Intro
Preset 4 / Random
Preset 5 / - 10
Preset 6 / + 10
2
TA/TP button
3
PTY button
4
AF/REG button
5
AS/PS button
6
Forward button
7
SELECT button
8
DIS button
12
BAND button
9
Mode button
13
Backward button
10
Mute button
14
Volume up/down buttons
Changing the battery
To change the battery, the battery compartment can be pulled out towards the front. Now replace the
old battery with a new one of the same type (CR 2025). Please pay attention to the polarity ("+ pole" to
the top) when you insert the battery. Please only touch the battery on the edge, since there might be
contact problems otherwise. Now slide the battery compartment with the new battery back into the case.
Make sure that the battery
compartment is positioned flush
inside the case again after
changing the battery.
7
GROUND ZERO
General operation
Detaching the control panel
- Turn the power off
- Press the open button to release the front panel
- Push the panel to the left in 45 degrees
and pull the panel towards you.
Attaching the control panel
- Insert the left side of the control panel into the
main unit.
- Press the right side of the control panel until
the “click” sound is heard.
Note! Do not insert DO NOT insert the control panel from the right side. It can damage the control
panel. The control panel can easily be damaged by shocks. After removing it, place it in a protective case
and be careful not to drop it or subject it to strong shocks. The rear connector that connects the main
unit and the control panel is an extremely important part. Be careful not to damage it by pressing on it
with fingernails, pens, screwdrivers, etc. Note: If the control panel is dirty, wipe off the dirt with soft, dry
cloth only. And use a cotton swab soaked in isopropyl alcohol to clean the socket on the back of the
control panel.
Resetting the unit
Operating the unit for the first time or after replacing the car battery, you must reset the unit. Press
OPEN button on the panel to open the panel and press RESET button to restore the unit to its original
factory settings.
Power on/off
Press any button (except OPEN) to turn on the unit. Press and hold PWR button on front panel or press
PWR button on remote control to switch the unit off.
Note! After the unit is off, the volume level and radio current settings will be memorized, and when you
turn the unit on it will resume the stored status you previously set.
Volume control
Rotate VOL knob on front panel or press VOL +/- buttons on remote control to adjust the volume level.
Turning the sound off
Press the MUTE button to turn the sound off. Press it again to turn the sound on.
Setting the sound characteristics
Short press and repeat SEL button to select the audio settings:
VOLUME => BASS => TREBLE => BALANCE => FADER=> EXIT.
Rotate VOL knob on front panel or press VOL +/- button on remote control to adjust each setting.
Note!
- If the unit is turned off, all the settings of each mode will be saved.
- If cutting off battery power or resetting the unit, all the settings will return to factory
default settings.
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ground zero GZCR 235USB at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ground zero GZCR 235USB in the language / languages: German as an attachment in your email.

The manual is 1,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info