790928
16
Zoom out
Zoom in
Previous page
1/20
Next page
16
d. Turn the switch OFF (O) and disconnect the power cord. Remove the pellets from the
pellet hopper. Check for foreign objects and wet or decomposed pellets, both of which
can cause a jam in the auger system. The auger will need to be removed to clear a jam in
the auger system. See ‘How do I remove the auger if it jams?’ see below.
3. HOW TO REMOVE THE AUGER IF IT JAMS?
1. Turn the switch OFF (O) and disconnect the power cord.
2. If the drill is still hot, allow it to thoroughly cool.
3. Remove any covers necessary to access the auger drive motor.
4. Remove the screw connecting the auger drive motor shaft to the auger shaft and the screw
retaining the auger bushing into the auger tube.
5. With a small pipe wrench or locking pliers on the auger shaft, turn the auger counter
clockwise. lt will turn hard until it breaks free, then the auger will turn freely.
6. Remove the auger and clean all pellets, ash or foreign objects from the auger, auger tube
and repot.
7. Sand the outside surfaces of the auger with medium grit sandpaper. Check the inside of the
auger tube and sand it if needed. Vacuum the sanding grit out of the auger tube and repot
when nished. Check that the auger rotates freely.
8. Re-attach the auger shaft to the auger drive motor shaft.
4. WHY DOES MY GRILL FIRE GO OUT ON SMOKE SETTING?
1. The ‘P’ number for the smoke adjustment on the digital control may be set too high.
Review the digital thermostat control functions in: ‘Operating tips’ to make an adjustment.
2. There may be excess ash in the repot which needs to be cleaned.
If the re in the repot goes out while smoking, when sufcient pellets are still in the pellet
hopper, it is important to follow these steps. Failure to do so may cause a hazardous ‘over-
ring’ of your grill due to an excess of unburned pellets in the repot.
a. Turn the switch OFF (O) and disconnect the power cord. If the grill is still hot, allow it to
thoroughly cool. Open the door and remove all food, the porcelain grills, grease drain pan
and the heat bafe.
b. Remove all unburned pellets and ash from inside and around the repot.
c. Before replacing the heat bafe, grease drain pan and the porcelain grills, plug the power
cord into an appropriate, grounded electrical outlet and turn the switch ON (I). Pellets
should fall into the repot and the hot rod should begin to heat (it will start to turn red).
Do not touch it.
d. If this procedure is successful, you will soon see ames come out of the repot. Then turn
the switch OFF (O), and let the grill cool down. Position the heat bafe, the grease drain
pan and porcelain grills in their proper locations. With the door open, turn the switch
ON (I) and the temperature/dial to ‘Smoke. In approximately 2 minutes you will notice
whitish-gray smoke coming out of the grill as the pellets ignite. After assuring the pellets
have ignited, close the door and set the temperature/dial to any cooking setting desired.
e. If this didn’t remedy the problem, contact Grill Guru technical support for additional
troubleshooting help.
5. WITH THE GRILL GURU DIGITAL CONTROL, WHAT DIAL SETTING IS
RECOMMENDED FOR STARTING THE GRILL?
The auto-start procedure is the same for all grill controls. With the door open, turn the switch
ON (I) and the temperature/dial to ‘Smoke. In approximately 2 minutes you will notice whitish-
gray smoke coming out of the grill as the pellets ignite. After assuring the pellets have ignited,
close the door and set the temperature dial to any cooking setting desired.
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Grill Guru Pellet Grill Large at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Grill Guru Pellet Grill Large in the language / languages: English as an attachment in your email.

The manual is 2.08 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Grill Guru Pellet Grill Large

Grill Guru Pellet Grill Large User Manual - Dutch - 17 pages

Grill Guru Pellet Grill Large User Manual - French - 17 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info