708280
15
Zoom out
Zoom in
Previous page
1/210
Next page
14
English (original instructions)
STARTING/STOPPING THE BLOWER See Figure 5.
1. Press the On/Off (
) Switch and you will hear two
audible beeps signaling the blower is active.
2. Squeeze the trigger to start the blower.Release the
trigger to stop.
ADJUSTING THE AIR VELOCITY See Figure 6.
1. Ensure that blower is on. The LED above the On/Off
Button will illuminate.
2. Press the Speed Selection Button(
) to increase
the air velocity to the desired setting.
IMPORTANT: THE CURRENT SPEED SETTING WILL
REMAIN EVEN IF THE UNIT IS TURNED OFF.
HOLDING THE BLOWER
Before operating the unit, stand in the operating position.
Check for the following:
Operator is wearing proper clothing, such as boots,
safety glasses or goggles, ear/hearing protection,
gloves, long pants and a long sleeve shirt.
WARNING
To avoid serious personal injury, wear goggles or
safety glasses at all times when operating this unit.
Wear a face mask or dust mask in dusty locations.
WARNING
To prevent serious personal injury or damage to the
unit, make sure the blower tube is in place before
operating the unit.
Assure the unit is not directed at anybody or any
loose debris before starting the unit.
Verify that the unit is in good working condition. Make
sure the tubes and guards are in place and secure.
Keep a firm grip on both the front and rear handle or
grips.
To reduce the risk of hearing loss associated with
sound level(s), hearing protection is required.
Operate power equipment only at reasonable hours
not early in the morning or late at night when people
might be disturbed. Comply with times listed in local
ordinances. Usual recommendations are 9:00 am to
5:00 pm, Monday through Saturday.
To reduce noise levels, limit the number of pieces of
equipment used at any one time.
To reduce noise levels, operate power blowers at the
lowest possible speed to do the job.
Use rakes and brooms to loosen debris before
blowing.
In dusty conditions, slightly dampen surfaces.
Conserve water by using power blowers instead of
hoses for many lawn and garden applications,
including areas such as gutters, screens, patios,
grills, porches, and gardens.
AIR VENTS
Never cover air vents. Keep them free from obstructions
and debris. They must always remain clear for proper
motor cooling.
WARNING
To avoid serious personal injury, do not wear loose
fitting clothing or articles such as scarves, strings,
chains, ties, etc., that could get drawn into the air
vents. To make sure long hair does not get drawn into
the air vents, tie back long hair.
OPERATING AS A BLOWER
Hold the blower firmly. Sweep from side to side with the
nozzle several inches above the ground or floor. Slowly
advance the unit, keeping the accumulated pile of debris
in front of you. Most dry blowing operations are better
suited to low speeds, rather than high. High speed
blowing is a better way to move heavier items like large
debris or gravel.
CLEANING
Remove the battery pack.
Brush or blow dust and debris out of the air vents
using compressed air or a vacuum. Keep the air
vents free of obstructions, sawdust, and wood chips.
Do not spray, wash, or immerse the air vents in
water.
■ Wipe off the housing and the plastic components using
a moist, soft cloth. Do not use strong solvents or
detergents on the plastic housing or plastic
components. Certain household cleaners may cause
damage, and may cause a shock hazard.
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Greenworks GD80BL - 2400407 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Greenworks GD80BL - 2400407 in the language / languages: All languages as an attachment in your email.

The manual is 23,8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info