644658
30
Zoom out
Zoom in
Previous page
1/42
Next page
30
MAINTENANCE
ADJUSTING THE CHAIN TENSIO (See Figure 34-35)
W A R N I N G
Never touch or adjust the chain while the motor is running. The saw chain is very sharp. Always
wear protective gloves when performing maintenance on the chain.
Stop the motor and remove the battery from the chain saw before setting the chain tension.
Slightly loosen the chain cover lock bolt.
Turn the chain tensioning bolt clockwise to tension the chain.
NOTE: A cold chain is correctly tensioned when there is no slack on the underside of the guide bar, the chain
is snug, and it can be turned by hand without binding.
on the drive links hang out of the bar groove.
NOTE: During normal saw operation, the temperature of the chain increases. The drive links of a correctly
tensioned warm chain will hang approximately 1/16" (1.3 mm) out of the bar groove.
NOTE: New chains tend to stretch; check the chain tension frequently and tension as required.
C A U T I O N
A chain tensioned while warm may be too tight upon cooling. Check the “cold tension” before
next use.
Fig. 34
Fig. 35
Flats On Drive Links
≈ 1/16" (1.3 mm)
0
30


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Greenworks 20312 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Greenworks 20312 in the language / languages: English as an attachment in your email.

The manual is 16,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info