637245

Graupner Ultramat 18 - 6470 Manual

40
Zoom out
Zoom in
Previous page
1/92
Next page
40
When a charge or discharge program comes to an end,
the screen displays the message END, alternating with
the program name. At the same time the integral buzzer
sounds for a limited period.
Ready message
15. Screen displays
Battery voltage
________________
________________
CHG 12:56 00321
NC+4.50A 11.98V
Program
Charge / discharge time
(min.:sec.)
Charge / discharge current
Capacity (mAh)
The two-line liquid-crystal screen displays in a clear form the important information generated
during the charge / discharge process. The information remains visible on-screen until you
disconnect the battery that is being charged. Once you connect another battery for charging, the
previously displayed values are erased, and cannot be called up again.
16. On-screen monitor displays
The ULTRAMAT 18 incorporates a wide range of protective and monitoring systems designed to
check the charger’s functions and monitor the state of its electronics. If any of the unit’s critical
limit values is exceeded, the charge process is switched off. Typical triggers would be excessive
voltage, excessive temperature or a depleted car battery.
If any of these problems should occur, the liquid crystal screen displays the cause of the error,
and the buzzer sounds to alert you.
________________
________________BATTERY CHECK
WAIT PLEASE...
Measuring process
When you hold the START button pressed in for about two
seconds, the charger measures the battery connected to
it. This message appears on the screen for one or two
seconds before the charge process is initiated.
Battery type
________________
________________
END 48:32 03363
NC 200mA 9.77V
Display with connected balancer connector
If the balancer connector of the battery is connected to the
charger and the balancer is activ, on the top of the left side BLC
is displayed alternating with the program name.
CHG
________________
________________BLC 28:30 02850
LP+6.00A 14.71V
… 40 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Graupner Ultramat 18 - 6470 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Graupner Ultramat 18 - 6470 in the language / languages: English, German, French as an attachment in your email.

The manual is 0,68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info