637253

Graupner POLARON EX-1400 - GR-S2018 Manual

21
Zoom out
Zoom in
Previous page
1/29
Next page
English
English
INNOVATION & TECHNOLOGIE
40 41
Submenu “HEATING“
In this sub-menu „HEATING“ you can choose a control program for battery
warmer pockets or alternatively a program for the control of tire warmers, by
tapping the appropriate icon, in both parts of the program the charger handles
both power consumption as well as the control of the connected heater.
Connect the battery or tire warmer connectors directly to the charge outputs
CH1 or CH2 and the temperature sensor to the associated sensor connector.
If necessary, both outputs are completely independent and they can be used
at the same time.
Display “Battery warmer“
# Parameter Short description
1 Temperature Adjustable in the range of 10 ... 45 ° C (default 25 ° C)
2 Alarm Adjustable in the range 1 ... 300 minutes (default 55 m)
3 Voltage Adjustable in the range of 5 ... 15 volts in 0.1 V incre-
ments (default 12.00 V)
4 0m Display of period since the program has started, time in
minutes
5 0s Display of period from the program has started, time in
seconds
6 00.0°C Display of the actually temperature measured by the
connected sensor
Pressing the ENTER buttons at the bottom right of the display starts the control program of the
battery warmer.
Pressing the STOP button at the bottom of the display stops the operation.
• The heater will continue heating even after the alarm!
• If you use a battery pack heat bag without temperature sensor, nor the tempera-
ture can be regulated neither the temperature can be displayed.
Set, for security reasons, the output voltage so that the battery does not overheat or even
ignite! Check the temperature reached on a regular basis or alternatively use one of the
temperature sensors supplied with the charger!
Display “tire warmer“
# Parameter Short description
1 Temperature Adjustable in the range of 10 ... 99 ° C (default 55 ° C)
2 Alarm Adjustable in the range 1 ... 300 minutes (default 55 m)
3 Voltage Adjustable in the range of 5 ... 15 volts in 0.1 V increments
(default 12.00 V)
4 0m Display of period since the program has started, time in
minutes
5 0s Display of period from the program has started, time in
seconds
6 00.0°C Display of the actually temperature measured by the
connected sensor
Pressing the ENTER buttons at the bottom right of the display starts the control program of the tire
warmer.
Pressing the STOP button at the bottom of the display stops the operation.
• The heater will continue heating even after the alarm!
• If you use a tire warmer without temperature sensor, nor the temperature can be
regulated neither the temperature can be displayed.
Set, for security reasons, the output voltage so that the tires do not overheat or even ignite!
Check the temperature reached on a regular basis or alternatively use one of the tempera-
ture sensors supplied with the charger!
Submenu “E.S.C“
In this submenu “ESC” (Electronic Speed Controller) can be programmed electronic motor control-
lers with three poles telemetry connector, analogue to the Graupner HoTT telemetry items.
NOTE:
• Once it is recalled the submenu “ESC” in a charge channel, the current on the other
charge channel process is interrupted.
• When connecting a controller with single-pole telemetry cable to the polaron EX-1400,
the data eld of the display remains blank due to incorrect data connection.
Bring the operating element of your motor controller in the OFF position BEFORE turning
your receiver system on or alternatively disconnect the motor from the speed controller!
Only in this way it is ensured that the motor cannot start in any way. Connect afterwards
- as exemplied in the gure below - your car controller three-pin cable telemetry to the ‘EXT.
MODULE “ side port. Alternatively you can use a servo tester with an external power supply to
control the motor controller in OFF position.
Once you have turned on the power to your controller and connected the controller input, the page
… 21 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Graupner POLARON EX-1400 - GR-S2018 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Graupner POLARON EX-1400 - GR-S2018 in the language / languages: English as an attachment in your email.

The manual is 4,52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info