467111
20
Zoom out
Zoom in
Previous page
1/345
Next page
20 General operating notices
Lithium battery CR 2032
On the side of the transmitter board opposite the
transmitter battery there is a fi xture containing a
lithium battery, type CR 2032, which can be replaced
by the user.
This battery maintains the date and time
settings during a transmitter power supply
outage, for example when the transmitter's
main battery is being replaced.
General charging instructions
Follow the charging instructions of the
charger manufacturer and battery manu-
facturer.
Do not exceed the maximum permissible
charging current of the battery manufac-
turer. To prevent damage to the transmit-
ter, the transmitter charging current should gener-
ally not exceed 1.5 A. Limit the charge current if
necessary.
If the transmitter battery is charged with more
than 1.5 A, it must be charged outside of the
transmitter. Otherwise, the printed circuit board
may be damaged from overloading the printed
connectors and/or overheating the battery.
Perform a few test charges to make sure that the
automatic cutoff of automatic chargers works.
This is especially true when you want to use an
automatic charger to charge the NiMH battery
which comes standard in the mz-18 HoTT trans-
mitter, or the lithium battery which comes stand-
ard in the mz-24 HoTT transmitter. Monitor the
cutoff behaviour if the charger that you are using
has this option.
Do not discharge the battery or run battery care
programs using the charging socket. The charg-
ing socket is only for charging.
Always fi rst connect the charging cable to the
charger, and then connect it to the receiver or
transmitter battery. This prevents unintentional
short-circuiting with the bare ends of the charging
cable plug.
If the battery becomes hot, check the battery and
exchange it or reduce the charging current.
Do not charge the batteries without
monitoring them.
Follow the safety instructions and han-
dling guidelines starting page
Stick length adjustment
The length of both sticks can be continuously ad-
justed to adapt these transmitter controls to the pilot's
preference.
Hold the lower half of the knurled grip in place then
turn the upper section to release its counter-locked
threads.
Now pull up or push down on the stick's end to the
desired length. When the length is suitable, tighten
the counter-locked threads of the upper and lower
sections again.
Lithium battery
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Graupner MC 32 HOTT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Graupner MC 32 HOTT in the language / languages: English as an attachment in your email.

The manual is 46,26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Graupner MC 32 HOTT

Graupner MC 32 HOTT User Manual - German - 320 pages

Graupner MC 32 HOTT User Manual - Dutch - 328 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info